Vortice VORT HR 350 AVEL User manual

Installation
For the HRU installation please refer to the instruction manual inside the
packa in .
If connection of the preheater and boost are needed, wires can be found
inside the slot (A) pic n°2.
In order to access this slot you need to remove the front cover of the
machine, to remove the cover please follow the instruction in pic. 4,5,6.
Once the cables are connected and the front cover closed, the machine can
be plu ed in the elctrical socket.
VORT HR 350 AVEL
Installation guide for
Australian market
Packaging
Inside the packa in you will find the HRU with the already connected
australian plu , as shown in pic. n°1.
A
N
L
PE GNYE
BU
BN
PREH
PREH
BN
BU
N
N
L
GND
BOOST
MAINS
BOOST
VCC
A
B
GND
HMI
5.571.084.391 14-11-2019
Wiring diagram
1
3
2

To unscrew
Torx T25
Removing front anel
While removin the front panel for maintenance, be
carefull not to pull the cables of the display (pic n°4,5).
Before completely removin the entire panel please
unplu the connector of the display behind it, than
remove the front panel.
4
5
Re-mounting
When mountin the cover back on, plu the display
connectors then put the cables inside the hole n°1
pic. n°6 and fix the front panel back in place with the
Torx screws.
1
6