Vuly Ring Swing User manual

MANUALRing Swing
Parts List
2x Pillow
4x Upper Tube
1x Padding
2x Foam
2x Side Joiner (right)
2x Lower Tube
2x Side Joiner (left)2x Side Tube
1x Base Mat
1x Hanging Joiner

MANUALRing Swing
Replace a Swing Rail on your swing set with the included
Ring Rail.
Ensure that the prongs are closer to the centre than the end
of the swing set.
Slide Foams over both Lower Tubes.
1
STEP
3
STEP
2
STEP
A. Insert Side Joiners (both left and right) into the corresponding
ends of a Lower Tube.
Ensure that the large hole on the Side Joiners is at the top.
B. Repeat for the other Lower Tube.
step2:covered with foam
make sure the place close to the middle side
Insert a completed Lower Tube into the
sleeves on both sides of the Base Mat.
4
STEP
step3:Go through the mat sleeve

I
I
1 : 5
MANUALRing Swing
Insert Side Tubes through the loops between the Left and
Right Side Joiners on both sides.
5
STEP
Attach the Hanging Joiner to the Ring Rail
on your swing set, and secure with the
large nut and bolt.
6
STEP
Step5：install the short tube and locking bolts
Insert the Upper Tubes into all four ends of the
Hanging Joiner.
7
STEP
Insert the Side Joiners on the completed lower half
of the Ring Swing into the Upper Tubes.
8
STEP

MANUALRing Swing
Place the Padding in the centre of the Base Mat
and the Pillows at the ends. Secure with Velcro.
9
STEP
step 7：Put the pad and
pillow on the mat，fixed
by velcro
You have attached the Ring Swing to your Vuly swing set.
CONGRATULATIONS!
DISCLAIMER
ATTENTION!
Safety information, installation and use instructions.
Read prior to installing and using the swings.
See VulyPlay.com/support for any updates to
these instructions.
WARNING!
• Minimum user age – 6 years. Only for domestic
and outdoor use.
• Maximum user weight per swing station – 80 kg
(175 lb) [65 kg (132 lb) on Spin Swing].
• Maximum combined user weight per swing set
section – 150 kg (330 lb).
• Adult assembly required. Adult supervision required
at all times.
• Ensure that the Swing Set is secured with anchors
or bolts before use.