
If your Swing is packaged with 2 foam coverings:
Slip them over the 2 rope sections at the very top of your Swing.
If your Swing is packaged with 1 foam covering:
Slip it over the rope section at the very bottom of your Swing.
VULY MINI:
Remove the first set of carabiners and the Height Adjustment
Straps on both sides of the Swing.
Unlock the carabiners on your Swing, and hook them into the
lugs on the Swing Rail.
VULY MAX:
Unlock the carabiners on your Swing, and hook them into the
lugs on the Swing Rail.
VULY QUEST:
Unlock the carabiners on your Swing, and hook them into the
accessory attachments on the Swing Rail.
Please ensure that the Accessory joiners on your Quest
Swing Rail are positioned at minimum 60cm apart.
Ensure that both carabiners are facing the same direction
and have been firmly tightened.
VULY MAX AND MINI:
Unlock the carabiners on your swing, and hook them into the
lugs on the Swing Rail.
VULY QUEST:
Unlock the carabiners on your Swing, and hook them into the
accessory joiners.
(Ensure that the Accessory Attachments on the Quest Swing
Rail are positioned at minimum of 51cm apart)
Ensure that both carabiners are facing the same direction.
PRE-INSTALLATION
INSTALLATION:
NEST SWINGS
To lower: Lift your Swing and feed the rope(s) up through the
Height Adjustment Buckles until you reach the desired height.
To raise: Lift the top(s) of the Swing rope(s) and feed down
through the Height Adjustment Buckles until you reach the
desired height.
HEIGHT ADJUSTMENT
INSTALLATION:
BABY, BOUNCE, SEAT AND WRECKING
You have attached your Swing onto your Vuly Swing Set.
CONGRATULATIONS!
Swings MANUAL
• Seat Swing
• Baby Swing
COMPATIBLE WITH
• Wrecking Swing
• Bounce Swing
• Nest Swing