WAHL
HOME PRODUCTS
®
Blades
Power Screw
On/Off Switch
Taper
Lever
Your New Clipper
Cord
Quick Start Guide
Easy step-by-step instructions included.
For more haircutting tips and techniques
visit wahlUSA.com.
Use for blending between
different hair lengths. The
taper lever adds versatility to
your clipper by allowing you to
gradually change the closeness
of your cut. (Up position =
closest cut; Down position =
longest cut)
(A) Oil blades as noted
on this sheet.
(B) You can reduce the
“clatter sound” by adjusting
the power screw. The power
screw was adjusted for peak
efficiency before leaving the
factory. However, if voltage in
your home is too high or low;
Blend it!
It’s Easy!
Too Noisy?
Helpful Hints
Use brush included to clean out excess hair on clipper and between blades (don’t clean with running water)
SAFETY FIRST! Please read instruction book first before using clipper
If defective contact Wahl via 1-800-767-9245
the clipper power screw may need adjustment.
Adjust Power Screw to Reduce Clipper Noise
(excessive clattering)
1. Turn your clipper “ON”
2. Use the end of the cleaning brush or a screwdriver to turn
power screw in a COUNTER CLOCKWISE direction until clatter
goes away.
Max Power!
Adjusting Power Screw for Maximum Power Setting
1. Turn your clipper “ON”
2. Use the end of the cleaning brush or a screwdriver to turn
power screw in a CLOCKWISE direction until you hear a
clattering noise.
3. Then turn power screw in opposite direction
(COUNTER CLOCKWISE) until clattering stops.
Haircutting Tips & Techniques
When you cut your hair, you should visualize the head as if it
were divided into four sections. Image above shows the
different sections. Using proper techniques when moving
from one section to the next will help you blend the sections
together for professional looking results. See instruction
book for more tips.
You can do it!
Section 2: Under the rim
of the head
Section 4: Top of the head
Section 1: The neckline
Section 3:The rim or side
©2019 part no: 92365-1002
v. 09.2019
Keep it Running Like New!
closest
cut
longest
cut
Adding Attachment Guards
Removing
Attachment Guards
Goof- Proof!
From underneath, lift tab up
to release from blade.
Align guard onto blade then press down where guard number
is located until you hear a snap.
For best results, place three
drops on front of the blades
and one drop on each side of
blade as shown. Use only the
Wahl Clipper Oil included in the
pack. Do not use hair oil, grease
or any oil mixed with kerosene
or any solvent.
The blades of your new clipper
should be oiled every few haircuts.
