Wahl 04230 User manual

1
2
3
4
5
6
3
Sec.
2 Programs2 Programs
Insert adaptor jack into the plug on the right
side of the unit.
Plug wall adaptor into AC 120V outlet or car
adaptor into cigarette lighter power supply.
To turn the unit on, press the power button on
the controller once.
To change the programs, press the power
button. Select from multiple settings by
pressing the programs button successively
until desired program is found.
To turn the heat on, press the heat button
once. Press again to turn heat off.
To turn the unit off, hold the power button for
3 seconds. This unit automatically turns off
after 20 minutes.
Wahl®Heated Lumbar Massage™Cushion Quickstart Guide
art no. 58413 (v.2021.04) © 2021 Wahl Clipper Corp., Printed in ChinaPlease contact us for additional information at WahlUSA.com or 1-800-767-9245.

Prepare for use at
home, in the office,
or in the car:
Place the unit in a
chair or car seat, and
pull the attached
elastic strap over top
of the chair or seat to
hold the cushion in
place. Make sure the
unit is flush with the
chair or seat to allow
for maximum benefit
of the lumbar support.
Programs
LOW Vibration — for
soothing massage
HIGH Vibration — for
vigorous, deeper
massage
OFF — if you prefer
heat only
Adaptor
Jack
Wall Adaptor
(Operates on
120V, 60HZ Only)
Car Adaptor
Adaptor
Jack
Heat Coils
throughout entire
Lumbar Support
4 Massage Nodes
in the Lumbar
Support
Adaptor
Cord
Plug for
Adaptor
Jack
Power
On/Off &
Programs
Button
Heat
Button
Wahl®Heated Lumbar Massage™Cushion Key Features
If you are not completely satisfied with your Wahl Massager, please contact us before returning this product at WahlUSA.com or 1-800-767-9245.