Wahl 04299 User manual

1
3
4
6
3
Sec.
2
4 Programs4 Programs
5
Wahl®Heated Foot Massager Quickstart Guide
Insert adaptor jack into the plug on the right
side of the unit. Plug into a AC 120-volt outlet.
Place foot massager on floor in front of chair
or sofa.
To turn the unit on, press the power button on
the left side once.
To change the programs, press the power
button. Select from multiple settings by
pressing the programs button successively
until desired program is found.
To turn the heat on, press the heat button
once. Press again to turn heat off.
To turn the unit off, hold the power button for
3 seconds. This unit automatically turns off
after 20 minutes.
part no: 58415-001 © 2020 Wahl Clipper Corp., Printed in ChinaPlease contact us for additional information at WahlUSA.com or 1-800-767-9245.

Power On/Off
& Programs
Button
4 Massage
Nodes
Heat
Coils
Heat
Button
Ergonomic
Kickstand
Plug for
Adaptor Jack
Programs
#1: Straight Vibration —
All motors vibrate
#2: Wave — All motors
vibrate slowly, gradually
getting faster, then left and
right sides alternate three
times, vibrating slow to
fast, then the program
repeats
#3: Pulse — pulses of
vibration get gradually
faster
#4: Left & Right Rotate —
alternates vibration
Caution: To avoid injury
and damage to the product,
always use this while
seated. Never stand on the
unit.
*It is highly recommended
not to use bare feet on this
unit. Also, do not use the
unit with shoes on.
Wahl®Heated Foot Massager Key Features
Adaptor
Jack
Adaptor
(Operates on
120V, 60HZ Only)
If you are not completely satisfied with your Wahl Massager, please contact us before returning this product at WahlUSA.com or 1-800-767-9245.