Walker Edison DWASH1D User manual

VIII.Drillmaybeneededforsecuringproducttowall.
P.2
General AssemblyGuidelines
I. Ensurethatallpartsandhardwareareavailablebeforebeginningassembly.
II.Followeachstepcarefullytoensuretheproperassemblyof thisproduct.
21
III. Twopeoplearerecommendedforeaseintheassemblyofthisproduct.
IV.Thethreemaintypesofhardwareusedtoassemblethisproduct are: wood
dowels,screwsand bolts.
V. Theprovidedglueistosecurewooddowelsinplace.Whenfirstinserting dowels,
locatetheappropriateholeforthedowel,placeasmallamountofglue inthe hole
andinsertthedowel.Wipeawayexcessglue immediately.
Infutureassemblystepswhendowelsarenecessarytoattachassemblyparts
together,placeasmallamountofglueontheendofthedowelbefore attaching
partstogether.Wipeawayexcessglueimmediately.
VI.APhillipsheadscrewdriverisrequiredfortheassemblyof thisproduct .
VII. Powertoolsshouldnotbeusedtoassemblethisproduct.
Copyright 2020 byWalkerEdisonFurnitureCo., LLC.All rightsreserved.Copyright 2020 byWalkerEdisonFurnitureCo., LLC.All rightsreserved.

PartsList
P.3
Copyright 2020 byWalkerEdisonFurnitureCo., LLC.All rightsreserved.
1
2
3
4
5
6
7
8
9
10
11
12
13

Insert wooden dowel (A) into parts (4,5,6) as per diagram.

Insert wooden dowel (A) into parts (1,7,8) as per diagram.

Secure cam bolt (B) into parts (1,4,12) with Philips head screwdriver as per diagram.

Secure cam bolt (B) into parts (2,3) with Philips head screwdriver as per diagram.

Pick up the slider arm (N) and separate the slide Runner for the following Steps. Extend
the Slide .Runner all the way forward,press the plastic release lever of the slider arm up
and pull the Slide Runner Complete out .

Using screw (K) attach slider (N) to parts (5,6,9,10) with Philips head screwdriver as
per diagram.

Using screw (J) attach parts (9,10) to part (11) with Philips head screwdriver as per diagram.
then put part (13) as per diagram.

Using cam lock(D) secure part (12) to parts (9,10) with Philips head screwdriver as per diagram.

Using screw (F) attach part (7) to parts (5,6) with hex key (G) as per diagram.

Using cam lock(C) secure part (4) to parts (5,6,7) with Philips head screwdriver as per diagram.

Using cam lock(C) secure part (7) to part (4) with Philips head screwdriver as per diagram.

Using cam lock(C) secure part (1) to parts (4,5,6) with Philips head screwdriver as per diagram.

Using cam lock(C) secure part (3) to parts (1,4) with Philips head screwdriver, then using
bolt (L) attach part (6) to part (3) with Hex key (G) as per diagram.

Using cam lock(C) secure part (2) to parts (1,4) with Philips head screwdriver as per diagram.

Using screw (H) attach part (8) to part (1) with Philips head screwdriver as per diagram.

Place sticker (E) cover the holes as per diagram ,and please pay attention on color of sticker.