
7
2003812_d•en•2016-08-01 We reserve the right to carry out improvements.
Button/
display Action/result
The WMS Wall mounted transmitter basic
does not find any device during scanning:
The transmission LED lights up.
ORANGE: No receiver found.
If the WMS Wall mounted transmitter basic
finds a receiver, transmitter or sensor that has
not yet been learned in, scanning is stopped.
It is indicated as follows:
The transmission LED lights up.
RED: New receiver
When you press the control button ,
you can check WHICH target device was
just found.
The product then waves and the control
function LED flashes.
GREEN: The target device is a receiver
for which the product type can
be adjusted.
By pressing the UP and DOWN arrow buttons,
you can select the desired receiver/product
type:
Press UP
Flashing increases by one
Press DOWN
Flashing decreases by one
Depending on the frequency with which
the control function LED flashes, the
corresponding product type is displayed:
1 x GREEN: Awning
2 x GREEN: Roller shutter
3 x GREEN: External venetian blind
4 x GREEN: Light
5 x GREEN: Window
To check which product type was set,
press the control button .
The flashing of the control function LED
indicates which product type was
selected.
Press the STOP button .
The appropriate product type is now
assigned to the receiver.
The transmission LED lights up for 2
seconds.
GREEN This confirms the assignment.
OTENThe first receiver that is learned into the WMS
Wall mounted transmitter basic defines the
channel type. If an external venetian blind is
learned in as the receiver first, the channel
type is defined as an external venetian blind
channel and only external venetian blinds can
be learned in.
The transmission LED flashes
GREEN: The scan process is now
repeated automatically until
no more new devices are
found.
The transmission LED lights up.
ORANGE: The scan is ended.
Briefly press the learn button to leave the
learn mode.
Example 6:
Delete learned-in products from the WMS Wall
mounted transmitter basic and the network
You can remove the learned-in products completely from
the WMS Wall mounted transmitter basic and the network.
First, scanning is repeated (see example 5 on page 6)
to identify the learned-in devices.
OTENDevices that do not need to be deleted must be
de-energised.
As soon as the transmission LED lights up orange, you
can start the deletion process.
Button/
display Action/result
Press the learn button on the WMS Wall
mounted transmitter basic for approx.
5 seconds.
+ The L LED lights up green; the
transmission LED flashes. For
several seconds, the WMS Wall mounted
transmitter basic scans the range for
receivers.
By pressing the learn button again, the
process can be aborted.
The L LED goes out.
If, while scanning, the WMS Wall mounted
transmitter basic finds a target device
(receiver, transmitter, sensor) that has already
been learned in:
The transmission LED lights up.
GREEN: Lights up continuously for
2 seconds
Then scanning continues.
The transmission LED lights up for
2 seconds.
ORANGE Scanning stops.
+ Press the STOP button and
simultaneously.
The delete command is sent to all learned-
in receivers.
Those receivers that are still learned-in wave
when they are deleted from the WMS Wall
mounted transmitter basic and the network.
The transmission LED indicates the result
of the deletion process:
The transmission LED flashes
GREEN: The devices are deleted.
The transmission LED flashes
RED: Not all target devices have
been deleted.
Press the STOP button .
The deletion command is sent repeatedly
to find receivers that were not within
the radio range during the first deletion
command and to delete them as well.
Briefly press the learn button to leave the
learn mode.
OTENWhen you delete a receiver from the network,
it can no longer be operated via other
transmitters. It must be relearned into a
network.