Warner RF FMT3.0 User manual

Contact:lanyue Email:[e-mail] Whatsapp:[phone]
FMT3.0 English Manual
The preparation：
First of all, please set up the antenna and connect to the transmitter RF OUT port
with RF cable。If you need to testing equipment indicators, please pick up the attenuator
is greater than kw，attenuation more than 50db。Connect the power cable then Access
to the XLR audio cable. There are “L” and “R” Channels。Turn on the “Power” button.
Equipment start after 5 seconds.

Contact:lanyue Email:[e-mail] Whatsapp:[phone]

Contact:lanyue Email:[e-mail] Whatsapp:[phone]
Transmitter operating interface:
1.Boot logo and system load
2.The main screen and enter the Settings
Current Frequency /Current
Power / Current SWR /Driving power tuning ratio Core temperature
Around a track the level of UV indicator 0,
0 db is full load.Please input signal does not exceed 0 db so as not to affect the audio
quality. But close to Odb or small audio sound.
External mo ulation：
External AUX input signal level indicator，Please do not enter the
margin level of more than 75 KHZ.
Mo ulation mo e: according to the external or internal and external modulation, the
external modulation input is enabled, the right of the level value - 3 db.Such as
display internal modulation, external input is disabled, the right of the level value - 3
db is invalid.
Soun mo e: stereo, mono, mute3 Kinds, 0 db on the right for voice level then mute
and external modulation invalid.

Contact:lanyue Email:[e-mail] Whatsapp:[phone]
Pre-emphasis: 50us /75u s, 0 means” close preemphasis.”
Press set button to enter the settings menu, six password into by default is 000008
Enter the passwor to enter the Settings menu
Select frequency into frequency setting, manual or sweep
Manually set into the manual tuning frequency.
Frequency sweep into the antenna standing wave ratio matching scanning.
Automatic frequency sweep the antenna standing wave ratio from 88- 08 MHZ for step
MHZ each with 20% of the entire section standing wave ratio of power to scanning
antenna.V.S.W.R is less than . 4 and less than . best, according to frequency after the
scan is complete.
Rate set button to enter the manual tuning frequency.

Contact:lanyue Email:[e-mail] Whatsapp:[phone]
Modulation mode menu: AF mode: audio mode is set.
Ex
ternal modulation: AUX input closed mixed. Pre-emphasis: audio pre-emphasis of choice
Modulation: AUX modulation level tuning. Volume: stereo/ mono volume level tuning.
3.System Settings menu:

Contact:lanyue Email:[e-mail] Whatsapp:[phone]
System at present time, the first time use please correct local time.
Device types and versions, continuous operation time and total run time.Default warranty time for 1
year or 2500 hours, the first to shall prevail.Equipment abnormal history record, store most recent
records.Record the type of exception and state. According to page UP and page Down could remove
all the records.
Press the button to enter time calibration set.
According to the password into password menu button.
Optional password closed and open,” open “by default.
Change: change user password.

Contact:lanyue Email:[e-mail] Whatsapp:[phone]
Password change Confirm change password input again.
Transmitter operation exception information
SWR high pls check your antenna.
Antenna at least five meters from the ground, around 0 meters without sunscreen.
Bending over 90 degrees will damage the feed tube
4.Transmitter troubleshooting tips
If transmitter appear this page, please remember the error code, namely the number
of internal error.The Numbers tell us.
Contact me: [e-mail] whatsapp:[phone]