Wasp Barcode Technologies WWS250i User manual

Pairing Wasp’s Bluetooth scanner models: WWS100i, WWS150i, WWS250i, WWS550i Page 1 of 2
Read the following instructions completely
before attempting to pair the scanner.
Start the Bluetooth pairing process for your PC or
device. Steps for some versions of Windows
are shown below (adaptable to other OSes).
. Right-click the Bluetooth icon in the system
tray near the clock, then click “Add a Device”.
2. Scan
3. Scan
4. Scan
5. When it appears in the pairing list, click Wasp
Barcode (or “Wasp Bar”) Bluetooth Keyboard,
then Next (or double-click it).
6. If you get a prompt about entering a pairing
code or Pin, go to Step 9 on the next page.
(Note: Scanners with newer firmware versions may
pair without prompting for a Pin. This is normal.)
7. Windows should say “This device has been
successfully added to this computer” or similar.
Click the Close button. Keep reading!
Important Note: Despite what the message above
says, Windows may still require more time
(possibly 2-3 minutes) to completely install the
device driver for the scanner. Watch for another
notification about the driver installation being
complete. Do not attempt to scan barcodes while
this driver installation is in progress; this can
prevent the scanner from pairing properly.
8. Test:
Launch Notepad, MS Word, or some other
application that accepts text input from a
keyboard, then scan a data barcode (e.g. Test
Symbols in Appendix A of the full user manual, or a
UPC barcode from a product). The application
should show the data from the barcode.
If the device repeatedly fails to pair, it may be in a
partially installed state. Go to Start menu, Devices
and Printers. In the Devices section, look for a
Wasp Barcode Keyboard (or similar name). If you
find one, right-click it, then Remove Device. When
that completes, go back to the beginning of this
procedure and try again.
If you entered a Pin, but the scanner beeps 5 times
when scanning a barcode, scan Stop Pin, then try
scanning again.
version 20 8083

Pairing Wasp’s Bluetooth scanner models: WWS100i, WWS150i, WWS250i, WWS550i Page 2 of 2
This page is for use only with a pairing code or Pin.
9. Click “Create a pairing code for me”, “Choose a
passkey for me”, “Or, try entering a passcode on
it”, or similar verbiage.
Windows 7:
Windows 8 (click the link below the box):
Notes:
• Do not enter the example code from
Steps 0 or 2, since your code will be different.
0. A pairing code will appear. Example:
. Scan
2. For each digit in the code shown on your
screen, scan its corresponding barcode (below).
For example, if your code is 5492208, start by
scanning the barcode for , then the barcode for 5,
then the barcode for 4, etc. until you have scanned
all digits in the code, then continue.
3. Scan the Enter barcode (below). Windows
should begin to install the device.
Continue with the procedure.
4. Scan Stop Pin (below). Go to Step 7.
• Do not scan all the barcodes below in order; instead match each code digit to a barcode digit (Step 2).
• Maintain a brisk pace; Windows times out quickly. If so, click Try Again, then go back to Step (Start Pin).
• You should hear only one beep per digit barcode. If there are three beeps, go back to Step (Start Pin).
• Don’t forget to scan Stop Pin in Step 4.
version 20 8083