Watermark RAYMOR Classic II Rimless P trap User manual

RAYMOR
Classic II Rimless P trap
Couple Toilet Suite
Installation set out for Classic ll Rimless Close couple Toilet Suite
Product Code: STD Seat Suite 194380
SET OUT DRAWING
Remove all products from packaging:
Check the product for damage, if the product is damaged return to the store of purchase, Check
the product is complete with all components required to install.
This product is to be installed by a licensed plumber, failing to do so will void warranty. This
product is to be installed as per Australian Standards and local authority requirements.
Warning: Do not bed the pan in place using cement, concrete OR SIMILAR MARTERIAL, DOING
SO WILL VOID THE PRODUCT WARRANTY.
Toilet Suite Installation
Toilet Pan Installation
N.B The distance from the back edge of the pan to the start of the ‘P’ trap is 10mm(due to
shrinkage variations please measure the distance on the pan to confirm) taking into account full
engagement of the pan collar on the ‘P’ trap. Install waste pipe as per Australian standards and
local authority requirements. The distance from the floor to the center of the ‘P‘ trap is 185mm,
set your waste pipe height accordingly.
1. Mark the centre line of the Pan connector on the wall for 'P' trap installation.
2. Place the pan into position centralising the pan on your centre line, draw around the pan base
and mark the entry points on the floor to where the floor fixing holes are on the side of the pan.
3. Remove the pan and drill and screw into place the floor fixing brackets, set the floor fixing
brackets 15mm inside the line drawn around the base. Use suitable floor fixing screws & toggles
to suit the floor material.

4. Critical, the pan must be on a level surface square to the wall, if the floor slopes away the pan
will need to levelled using suitable floor chocks around the pan to support and stabilise the pan.
Toilet cistern installation
1. Marking Cistern wall fixing holes- place cistern onto Pan without sponge gasket, square up cistern
to pan and mark wall through cistern fixing holes, remove cistern and drill wall and fit wall plugs
based on wall material.
2. Locate the cistern on to the pan with the sponge gasket placed on the cistern outlet valve tail
and connect the tank to pan using attachment bolts. Ensure that the cistern and pan are china to
china contact when tightened DO NOT OVER TIGHTEN.
3. Screw cistern to wall using suitable screws and preassembled wall plugs.
4. Connect one end of the supplied Female to female Flex connector to the inlet valve (DO NOT
OVERTIGHTEN), connect the other end to mains Water. (DO NOT OVER TIGHTEN).
5. Place cistern lid on top of the cistern and check push button workability.
6. Assemble the seat using the seat assembly instructions supplied in the seat box
Important: Sand and debris move through water pipes. Always flush the line prior to
connecting Toilet Suite inlet pipe to water control valve.
Warranty Contact Details:
Tradelink Pty Ltd
ABN: 29000003832
1051 Nudgee Rd
Banyo QLD 4014
Ph: 1300 658 277
[e-mail]
Warranty:
For continued piece of mind, this product comes with limited warranty from date of purchase.
For full warranty terms and conditions of the warranty including how to claim and your rights as a
consumer, please consult www.raymor.com.au .
“If you are a consumer as defined under the Australian Consumer Law, our goods come with
guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be
of acceptable quality and the failure does not amount to a major failure.”
Issue Date: 10 Oct 2020
Revision Number: 1.0
Revision Date: N/A