Watermark vito bertoni alder tapware User manual

For all servicing needs, please contact CUSTOMER SERVICE on:
FREECALL: 1800 800 919 PHONE: [phone] FAX: [phone] EMAIL: [e-mail]
www.aldertapware.com.au www.vitobertoni.com.au V05 171017
alder tapware
PRODUCT: QAAD WALL BASIN / BATH SET W/- BACK PLATE
WARRANTY
The warranty will be void if the following occur:
•Exposure to pressures that exceed 500 Kpa and or temperatures that exceed 75oC within a building –Refer
AS/NZS 3500.1:2003 (Clause 3.34):
•Damage to the ceramic disc cartridge from foreign matter e.g. sand, dirt, stones, thread tape, pieces of
copper or plastic tubing etc:
•Inadequate flushing of system prior to usage, causing damage and/or obstructions to the product:
•Damage to product surface due to installation (including adhesives and sealants):
•Failure to install flow regulators and check valves from outlets including showers,
sink and vegie mixers: and
•Products fitted with other devices to the outlet e.g. water filters
NIPPLE
CUTTER
REQUIRED

For all servicing needs, please contact CUSTOMER SERVICE on:
FREECALL: 1800 800 919 PHONE: [phone] FAX: [phone] EMAIL: [e-mail]
www.aldertapware.com.au www.vitobertoni.com.au V05 171017
INSTALLATION: QAAD WALL BASIN / BATH SET W/- BACK PLATE
Diagram #1 Mark desired position of wall set and fit screw on left hand side of install plate
Diagram #2 With the DOTTED LINE on the wall mixer cover at the 12 O’CLOCK POSITION, use levelling
tool as shown and mark the right-hand side screw hole
Diagram #3 Fit screw on right hand side –check level –fit two additional screws in center for stability
Diagram #4 Remove PLASTIC GUIDE to complete tiling
Diagram #5 After tiling, push 5MM PLASTIC SPACER over 19BP Elbow (5mm PLASTIC SPACER can be
found in rear of WALL PLATE) –use NIPPLE CUTTER* (see below) to reduce length of 19BP Elbow to a
5MM PROTRUSION FROM THE TILE FACE
Diagram #6 Remove 5MM PLASTIC SPACER and assemble CONNECTOR onto the 19BP Elbow –screw
CONNECTOR up to tile face
Diagram #7 Install WALL PLATE
Diagram #8 Complete assembly by attaching handle and spout as shown
* Recommended NIPPLE CUTTER –Reliance Worldwide Product Code A60-001