Watermark Loft Wooster L8 User manual

Loft
Widespread Lavatory Set
Loft – Widespread Lavatory Set Page 1
FEATURES
•¼ turn washerless ceramic disc valve
cartridges
•Flexible hose connection for 8” to 16”
spread installations
•Flow rate 1.2 gpm (4.5 lpm) maximum
flow rate
•Solid brass construction
•Warranty:
oLimited lifetime warranty
(residential use)
oOne year (commercial use)
•Standard finishes:
opolished chrome
osatin nickel
opolished nickel
orustic brass
•Listed by IAPMO, CSA, NSF, and other
municipalities
•Shipping weight (lbs.) 10
•Shipping dimensions (in.): 23x13x5
Part #
Description
1
Spout
2
Deck Gasket
3
Mounting Washer
4
Lock Nut
5
Rubber Mounting Washer

Loft
Widespread Lavatory Set
Loft – Widespread Lavatory Set Page 2
Carefully remove all parts from the box.
1. Begin by first installing the Spout.
a. Remove the "T" Assembly (6,7) from the Spout (2).
b. Drop the Spout through the hole in your countertop or sink.
c. Tighten the Lock Nut (5) against the underside of mounting surface.
d. Re-assemble "T" Assembly onto bottom of Spout.
2. Identify your Hot and Cold Valves.
a. Remove all trim from Valve Assembly (including Lock Nut [11] where applicable), leaving
Bottom Lock Nut [12].
b. Push the valve from the bottom of the deck through the hole on the deck and thread the Lock
Nut [11] onto the valve. Make sure the top of the Lock Nut [4] is flushed with the end of
cartridge stem.
c. Put the entire handle trim [1] onto the Top Lock Nut [4], make sure the broached hole on the
handle engages with the cartridge stem.
d. Thread the handle escutcheon onto the top locknut [4] until it bottoms out to the deck.
e. Adjust position of handle then tighten the locknut on the valve.
3. Connect the two Flex Hoses (13) to "T" Assembly (7) and to the HOT (14H) and COLD (14C)
valves, respectively. These hoses can be bent or twisted but be careful not to kink the hoses
or you will have limited water supply and excessive noise from the faucet.
4. Begin by bleeding the water lines before connecting to the valves. Connect water supplies to
bottom of each valve.
5. Remove flow restrictors found in both inlets of “T” Assembly (7) and flush faucet by running
both Hot and Cold water in fully open position. Replace the flow restrictors.
6. Check for leaks. If leaks or problems occur, re-tighten all nuts before consulting a plumber.
NOTE: The above instructions apply to the “A” handle trim.
23-2.18-SPT-ASSY
23-2.17-SPT-ASSY
23-2-SPT-ASSY

Loft
Widespread Lavatory Set
Loft – Widespread Lavatory Set Page 3
Handle Trim
Wooster (Code: L8)
Handle Trim
Prince (Code: L9)
IMPORTANT INSTALLATION INFORMATION
•USE TEFLON TAPE OR PIPE SEALANT FOR THREADED CONNECTIONS
•DO NOT USE PLUMBER’S PUTTY ON ANY OF THE BRASS COMPONENTS
This will cause the finish to tarnish and void the warranty. A non-corrosive Alkoxy Silicone is
recommended.
•DURING SWEATING OF LINES DO NOT OVERHEAT CASTING
Overheating may cause damage to internal mechanism
•
COPPER ADAPTORS MAY BE REQUIRED TO COMPLETE YOUR INSTALLATION
For technical support, please call 718-257-2800