Watermark aquaBUBBLER AB12 User manual

(S2)
45
6
Classic/Universal aquaBUBBLER
7
Timber boxing foundation
Screws and washers
Bag of cement
Socket Extension Bar
10 mm threaded rod and nuts
Flexible head ratchet wrench
43 mm hole saw
15 mm hole saw
10 mm socket
1
2
3
4
5
6
7
8
9
Where installed in frost-prone
areas, unit must be fitted with an
Anti-Freezing Valve. Warranty
will otherwise be void
Determine Orientation
Identify Water & Drainage points
Is an Anti-Freezing Valve Required?
IMPORTANT >>>
Determine Plumbing Connection
3
SPORTS FIELD
Wall
WALKWAY
CORNER
1
Outdoor Indoor
2
Install onto :
Plumbing Tools Required
Pre-installation
Below GroundAbove Ground
Keyhole
Locate Keyhole OUTSIDE
Black Zone for accessibility
Location:
1
ATTENTION PLUMBER: See next page for INSTALLATION GUIDE
Concrete
Pad
Ground
Work Timber Floor
Product Code: AB12/ABUA13/AB2UA14
WASTE
W A TER
WASTE
W A TER
Unit must be installed by a Certified Plumber - failure to do so will void all warranties.
1
2
34
5
6
7 8 9

2
78
Attach Side Pod
Connect pipe to
tap fitting
Connect Black
Director from
Pod to the
Waste Pipe
Screw Side Pod
to body with a
5mm Allen Key
(not supplied)
Insert coach bolts
through square
holes (either side
of DB)
Secure bolts from
inside of unit
with washer and
lock nut
1
2
1
1
2
3
2
3
3
(S2)
Mark measurements and
dimensions as indicated by
Schematic
1Consult
Schematic
DON’T FORGET:
Seal all plumbing
Apply sealant to
T-junction pipe ends
before insertion into
other pipes
Check for leaks
Run taps and adjust
any insecure
connections
Attach DB
aquabubbler.com.au/plumbing-technical-information
ATTENTION PLUMBER: See previous page for PRE-INSTALLATION GUIDE
345
2Locate Internal Base Mounting Plates
water
supply water mains
DON’T Install S-Trap
below the pod !!
Pod has its own
in-built S-Trap
Install
Isolation Valve
(not supplied)
Flush out
the lines
before connecting
to unit in order
to eliminate
particulate
matter
(copper &
brass filings)
Using plates as templates for unit
orientation, mark rod positions on
ground through holes
Fix 10mm threaded rods
into ground
Remove lid with T15
Post Torx Security
Screwdriver (supplied)
Remove PVC S-Trap
to gain access
Insert plates
through base of unit
Lower unit over
fixed rods
on mains line,
external to unit
(recommended)
SET UP FOR USE:
Run the tap
Adjust water pressure
Rotate keyhole with a
5mm screwdriver to
adjust water pressure
until the pod is full
Advise client to check
water pressure 48 hours
aer installation, as it may
require re-adjustment
Leave T15 Post Torx
Security Screwdriver
with client
Classic/Universal aquaBUBBLER
IMPORTANT >>>
Installation
Product Code: AB12/ABUA13/AB2UA14
Unit must be installed by a Certified Plumber - failure to do so will void all warranties.
6a 6b
Universal
aquaBUBBLER
only
Units with
Dog Bowl (DB)
only