Watermark MPU6 User manual

MPU6 Soft Touch Lavatory Drain Without Overflow
350 Dewitt Avenue, Brooklyn, NY 11207 USA T 718.257.2800 F 718.257.2144 www.watermark-designs.com Page 1
Parts Breakdown and Dimensions
ITEM NO.
DESCRIPTION
QTY
1
Cap
1
2
Cap Gasket
1
3
Plunger
1
4
Body
1
5
Top Gasket
1
6
Bottom Gasket
1
7
Washer
1
8
Nut
1
9
Tail
1

MPU6 Soft Touch Lavatory Drain Without Overflow
350 Dewitt Avenue, Brooklyn, NY 11207 USA T 718.257.2800 F 718.257.2144 www.watermark-designs.com Page 2
STEPS
1. Unscrew the tail from
the body.
2. Unscrew the nut
and remove the
washer and the
bottom gasket
from the body.
3. Place the rest of the
drain into the sink from
the top. If the cap has a
Watermark logo on it
then make sure to align
it to the desired
orientation.
4. Place the
bottom gasket on
top of the nylon
washer, then place
the nylon washer
on top of the nut,
finally screw the
nut back onto the
body. Do not over
tighten the nut.
5. Apply Teflon tape to the thread on the tail and
screw the tail back into the body.
6. Connect the drain to the trap and check for
leaks.
IMPORTANT INSTALLATION INFORMATION
•USE TEFLON TAPE OR PIPE SEALANT FOR THREADED CONNECTIONS
•DO NOT USE PLUMBER’S PUTTY ON ANY OF THE BRASS COMPONENTS
This will cause the finish to tarnish. A non-corrosive Alkoxy Silicone is recommended.
•DRAINS ARE ONLY UNDER WARRANTY FOR MECHANICAL FAILURE, NOT FOR FINISH DEFECTS
For technical support, please call 718-257-2800