Waterpik WP-480 User manual

QUICK START GUIDE
1
3 4
Model WP-480
The battery charger is only compatible with a voltage system of 120VAC, 60Hz.
Do not plug the battery charger into a voltage system that is different.
continued on back
The Water Flosser
has 3 settings on the
power switch. O (off),
I (low), and II (high).
Use the low (I) setting
for first time use.
Increase to high (II)
pressure over time, if
you prefer – or as
instructed by your
dental professional.
Battery Pack Insertion:
Insert Tip: Adjusting Pressure:
Charge battery pack for
24 hours before first use
Slide battery pack
into handle, lining
up the arrows and
rotate clockwise
until it locks into
place. The arrow on
the battery pack will
line up with the lock
symbol on the back
of the Water Flosser.
Select the appropriate tip and insert
into the unit. Press firmly until the tip
clicks into place. Gently pull on tip to
confirm it is seated
properly and locked
in place.
Plug charger into standard
electrical outlet (1). Line up
arrow on the battery pack
with arrow on the charger
labeled “insert” and insert
battery pack (2). Rotate
battery pack until arrow
lines up with arrow labeled
“charge” (3). Green light on
the charger will illuminate.
For Showerpik® installation instructions, please see instruction book
Caution: Do not press
tip eject button while
unit is running.
2
charge
Insert
charge
Insert
1
2
3
NO
Gap
Tip
Eject
Button
Insert

7
5
6REGISTER
YOUR PRODUCT
ONLINE NOW!
Receive up to
$44
in savings on the
purchase of additional
Waterpik® products.
www.waterpik.com/registration
20015713-F AA
Aim the water stream just above
the gumline at a 90 degree angle.
Always place tip
in mouth before
turning unit on.
Starting with the back teeth, follow
the gumline and pause briefly
between teeth.
Continue until all areas around and
between teeth have been cleaned.
Tip Removal:
Technique Tips for Best Results:
Water Pik, Inc. 1.800.525.2774 www.waterpik.com
1730 East Prospect Road, Fort Collins, CO 80553-0001 USA ©2012 Water Pik, Inc.
To remove the
tip from the
handle, press
the tip eject
button and
pull tip from
the handle.
To confirm correct
water temperature, turn
unit on and run water
into hand and adjust
water temperature as
desired. Turn unit OFF.
Prior to turning unit on,
place tip in mouth, aim
tip toward teeth, and
turn unit ON.
Eject
Tip
Eject
Button