Waterpik Complete Care CC-01 User manual

Mode
Clean
Whiten
Massage
CHARGE
ON
OFF
ON
OFF
Models CC-01 & CC-02
QUICK START GUIDE
Fill
Slide to
Eject
This device is compatible with voltages of 100-240VAC, 50/60Hz ©2018 Water Pik, Inc.
Getting Started (First time use only)
1
Power
ON
Water
ON
High
Fill reservoir with warm
water and replace it firmly
on the base.
Insert tip firmly until
it clicks into place.
Turn pressure to high, point
tip into sink. Push power on
and slide water switch on.
Leave on until water flows,
then turn off.
ON
OFF
ON
OFF
Insert
6”

Water Floss
2
Start on low pressure.
Turn power and water on.
Increase pressure to your
liking.
Close lips enough to
prevent splashing, while
still allowing water to flow
from mouth into the sink.
Aim water at the gumline at a
90° angle. Follow the gumline
and pause briefly between teeth.
TO AVOID MESS: PLACE THE TIP IN YOUR MOUTH BEFORE TURNING WATER ON
Models CC-01 & CC-02
QUICK START GUIDE
Power
ON
Water
ON
Low
Mode
Clean
Whiten
Massage
CHARGE
ON
OFF
ON
OFF
FN 20026587-F AA
6”