Waterpik Water Flosser WP-260 User manual

QUICK START GUIDE
Model WP-260
1Prepare the Reservoir:
Remove the reservoir from
base and fill with lukewarm
water.
Replace the reservoir onto the
base, PRESSING DOWN FIRMLY
to ensure full seating.
Fill
Replace
When tip is properly
inserted there should be
no gap between handle
and colored tip ring.
2Select and Insert Tip:
4
Prior to Very First Use of Unit, Prime
Unit:
Set pressure control dial on base to
high, point the handle and tip into sink.
Turn unit ON until water flows from the
tip. Turn unit OFF.
3Prime Unit (First Time Use Only): Adjust Pressure Control:
For first time users, adjust pressure
control to lowest position. Gradually
increase pressure to your liking.
Press tip
firmly into
handle.
Low
I
12
3
O
High
I
12
3
O
NO
Gap
12
3
I
O
Insert
12
3
O
This device is compatible with global voltages of 100 - 240VAC, 60/50Hz.
continued on back

6REGISTER YOUR
PRODUCT
ONLINE NOW!
Receive up to
$44
in savings on the purchase of
additional Waterpik® products.
www.waterpik.com/registration
On
12
3
I
O
Aim the water stream just above the
gumline at a 90 degree angle.
Starting with the back teeth, follow
the gumline and pause briefly
between teeth.
Continue until all areas around and
between teeth have been cleaned.
Turn unit OFF.
Using your Waterpik® Water Flosser:
5
Lean over sink and close lips enough
to prevent splashing, while still
allowing water to flow from mouth
into the sink. Turn unit ON.
Always place tip in mouth
before turning unit on.
Tip Removal:
Slide the tip eject button up
on the handle. Remove the tip.
Caution: Do not slide tip eject
button while unit is running.
7
Tip
Eject
Up
FN 20013604-F AB
Water Pik, Inc. 1.800.525.2774 • www.waterpik.com
1730 East Prospect Road, Fort Collins, CO 80553-0001 USA ©2011 Water Pik, Inc.
12
3
O
Remove