Watershed Innovations HydraBarrier Titan User manual

HydraBarrier Titans are heavy even when empty. Always use caution when handling
and filling.
HydraBarrier HydraBarrier Titan Instructions
Warning
Preparation and Placement
1. Remove the Titan from its packaging.
2. Place Titan in front of the area you would like to protect but make sure
area is free of sharp or pointy objects. Also, make sure that the fill spouts are
located on the top of the barrier.
Tip: Take time to carefully place the barrier in the desired position. Once the barrier begins
to fill it will quickly become heavy and difficult to move.

1. For HydraBarriers Titans with black filler cap, simply unscrew to open.
Large Opening Filler
Some HydraBarrier Titans have a large filler tube. This will allow a large diameter
hose (up to 4”) to be used for filling.
1. To use, simply unroll the large filler tube and insert hose into the opening.
Filling
There are two fillers that are available for the Titan.
Black Filler Cap
2. Close when full.

Watershed Innovations Company, LLC [phone]
2. You can clamp the tube for easier filling
3. Once filling is complete roll up top and use the attached tie to secure filler
tube, ensuring that it is closed.
Trademarks and/or registered trademarks of Watershed Innovations Company, LLC Information is
subject to change without notice. Copyright Watershed Innovations Company, LLC. All rights
reserved. HydraBarrier™ and its accessory products are covered by a Limited Liability Warranty
good for one month (30 days) from the date of purchase. Please see www.hydrabarrier.com for
complete warranty information.