WE-EF VFL530 User manual

WE-EF LEUCHTEN
Installation and Maintenance
Instructions
Street andArea Lighting Luminaire
VFL530
VFL540
Do not open during installation
This product is factory-sealed.
Refer to the instructions contained in this
document for details.
Surge Protection
This product features built-in surge protection circuitry in compliance
with applicable standards.
For comprehensive protection of a luminaire installation against lightning
and electrical surges,it is essential to cover mains supply and data input
lines at the distribution board level,by using respective primary (Type 1)
and secondary (Type 2) surge arrestors in compliance with EN61643-11/
IEC61643-1.
Warning
Ensure that all required surge protection measures are in place and
activated prior to luminaire installation.Also, disconnect luminaires
before operating high-power devices such as, for example,electrical
arc welders.

1
Street and Area Lighting Luminaire
ø 60 x 80
ø 76 x 80 or
100
330
470
ø 60 x 80
ø 76 x 80 or
100
590
330
VFL540 LEDVFL530 LED
IP66, IK08, Class I, ta = 25°C
114
50
Mounting height m
for VFL530/VFL540 3 - 6
Weight kg
for VFL530 - 12 LED max 6.4
for VFL530 - 24 LED max 6.6
for VFL540 max 8.4
Windage area m
2
VFL530 0.040
VFL540 0.046
Installation: horizontal,light output downwards,
Suitable for spigot diameter D = 60 x 80 mm or D = 76 x 80 mm
8SSHUSROHRĪVHW'PD[PP
D
D1
50 114

2
Light Source
LED
Maintenance
Apart from cleaning the product’s exterior surfaces,no special maintenance work is required.
Do not use high-pressure cleaners.
In case of component failure due to abnormal circumstances or at end of life, replacement must be carried
RXWE\DVXLWDEO\TXDOLĥHGDQGWUDLQHGSURIHVVLRQDO
Warning: Do not open luminaire while mains supply is switched on.
For Wild-Light applications,refer to separate TO9281W instruction for Wild-Light motion box.

3
Installation Procedure
 6ZLWFKRĪPDLQVHOHFWULFDOVXSSO\
2) Check that rating shown on luminaire label
conforms with mains electrical supply.
3) Feed mains cable Cinto pole D, while setting
luminaire assembly in position.Tighten screws B.
4) Trim mains supply cable Cto the desired length
and connect leads to their respective terminals at
the base of pole (L = Phase, N = Neutral,
= Earthing)
Installation
The product must be installed and maintained
E\DVXLWDEO\TXDOLĥHGSURIHVVLRQDOLQFRPSOLDQFH
with latest building/construction and/or electrical
regulations and relevant legislation.
The supply cable must be installed inside the pole
and not be exposed to the outside environment.
Warning:6ZLWFKRĪPDLQVHOHFWULFDOVXSSO\SULRUWR
installing and connecting the luminaire.
Notice:,IWKHOXPLQDLUHLVPRGLĥHGE\DQ\ERG\RWKHU
than the original manufacturer, then the warranty will
no longer be valid and shall become the full
responsibility of the modifying person/organisation.
Claims based on defects attributable to improper
installation and/or application,and the consequences
thereof, are excluded.
Attention: The luminaire is factory-sealed and does
not need to be opened during installation.
The installation on site must comply with local and/or
national health and safety regulations.

4
D
C
B
D1
L
N
Supply cable

TO9183W0823© WE-EF 2023
7HFKQLFDOVSHFLĥFDWLRQVDUH
subject to change.
www.we-ef.com
WE-EF LEUCHTEN
Germany
Tel [phone]
Fax [phone]
[email protected]
WE-EF LUMIERE
France
Tel [phone]
Fax [phone]
[email protected]
WE-EF SWITZERLAND
Switzerland
Tel [phone]
Fax [phone]
[email protected]
WE-EF LIGHTING
Thailand
Tel [phone]
Fax [phone]
[email protected]
WE-EF LIGHTING
Australia
Tel [phone]
Fax [phone]
[email protected]
WE-EF LIGHTING
United States of America
Tel [phone]
Fax [phone]
[email protected]

WE-EF LEUCHTEN
Installation and Maintenance
Instructions
Post Mounted Luminaires
Wild-Light motion box

1
Box motion for Wild-Light
SLC box motion

2
Light Source
LED
Maintenance
Apart from cleaning the product’s exterior surfaces,no special maintenance work is required.
Do not use high-pressure cleaners.
In case of component failure due to abnormal circumstances or at end of life, replacement must be carried
RXWE\DVXLWDEO\TXDOLĥHGDQGWUDLQHGSURIHVVLRQDO
Warning: Do not open product while mains supply is switched on.

3
Installation
The product must be installed and maintained by a VXLWDEO\TXDOLĥHGSURIHVVLRQDOLQFRPSOLDQFH
with latest building/construction and/or electrical regulations and relevant legislation.
Warning:6ZLWFKRĪPDLQVHOHFWULFDOVXSSO\SULRUWRLQVWDOOLQJDQGFRQQHFWLQJWKHSURGXFW
Notice:,IWKHSURGXFWLVPRGLĥHGE\DQ\ERG\RWKHUWKDQWKHRULJLQDOPDQXIDFWXUHUWKHQWKHZDUUDQW\ZLOO
no longer be valid and shall become the full responsibility of the modifying person/organisation.Claims
based on defects attributable to improper installation and/or application,and the consequences thereof,
are excluded.
Attention: The product is factory-sealed and does not need to be opened during installation.
The installation on site must comply with local and/or national health and safety regulations.

4
1) Identify the right location for the motion box on the pole. Note that the sensor has to be directed
downwards and be installed in a height between 0 and 6 m*.
* Separate box for 6-12 m available on request
Installation Procedure for Wild-Light
2) Prepare a cable entry hole in the pole.Avoid sharp edges that could damage the cable.
0-6 m
ø 15 mm

5
3) Insert the cable of the motion box in the pole through the cable entry hole.
4) Install the motion box to the pole, e.g. by means of stainless steel bands (not provided by WE-EF).
12

6
5) Trim the motion box cable to the desired length and connect leads to their respective terminals at
the base of pole by means of the provided sealable junction box.
6) The configuration of the motion box is done via eSave SL configurator software and requires an
eSave SL-Control USB stick. For further information, please contact WE-EF.
Mains supply
Luminaire
Motion box
L1 L1
L N DA DA
DALI
DALI
NN

www.we-ef.com
WE-EF LEUCHTEN
Germany
Tel [phone]
Fax [phone]
[email protected]
WE-EF LUMIERE
France
Tel [phone]
Fax [phone]
[email protected]
WE-EF SWITZERLAND
Switzerland
Tel [phone]
Fax [phone]
[email protected]
WE-EF LIGHTING
Thailand
Tel [phone]
Fax [phone]
[email protected]
WE-EF LIGHTING
Australia
Tel [phone]
Fax [phone]
[email protected]
WE-EF LIGHTING
United States of America
Tel [phone]
Fax [phone]
[email protected]
TO9281W0523 © WE-EF 2023
Technical specifications are
subject to change.