Webasto Telestart T70 User manual

F 46 0006 R
Aufrüstungssatz Standheizung mit FernbedienungT70
BMW 3er-Reihe, Limousine (E46/4) Linkslenker
Modelle mit M47 Motor bis 9.99
Park Heating with Remote ControlT70 kit
BMW 3 Series, saloon (E46/4) left-hand drive
Models with M47 engine to 9.99
Kit de deuxième monte "chauffage auxiliaire" avec télécommandeT70
BMW Série 3, berline (E46/4) direction à gauche
Modèles à moteur M47 jusqu'à 9.99
Uitbreidingsset parkeerverwarming met afstandsbedieningT70
BMW 3-serie, sedan (E46/4), linksgestuurd model
Modellen met M47 motor tot 9/99
Monteringssats kupévärmare med fjärrkontrollT70
BMW 3-serie, sedan (E46/4) vänsterstyrd bil
Modell med M47 motor t.o.m. 9/99
Teile und Zubehör – Einbauanleitung
Nachrüst-/Einbausatz-Nr.: 82 30 0 020 941 Stand: 05.2000
EBA Nr.: 01 29 0 021 305

F 46 0006 R
Park Heating with Remote ControlT70 kit
BMW 3 Series, saloon (E46/4) left-hand drive
Models with M47 engine to 9.99
(Only for use within the BMW trading organisation)
Technical knowledge is required.
Installation time approx. 1.5 hours, which can vary according to the condition and fittings of
the vehicle.
If the optionalTimer is to be fitted, installation time is increased by approx. 0.25 hours.
Retrofit/Installation Kit no. 82 30 0 020 941
BMW Parts and Accessories
Installation Instructions
Retrofit/Installation Kit no. 82 30 0 020 941 Date: 05.2000
Installation Instructions no. 01 29 0 021 305

Contents
Chapter Page
1. Necessary preparatory work on the vehicle ................................................................24
2. Installation and cabling diagram ..................................................................................25
3. Connection diagram ....................................................................................................26
4. Check state of the art of the model and if necessary change plug connector and
blower regulator (only vehicles with IHKA automatic heating and air conditioning
to 9.98) ........................................................................................................................27
5. Install park heating wiring harness and connect it ......................................................28
6. Install antenna and receiver ........................................................................................30
7. Install timer (optional) ..................................................................................................31
8. Coding ........................................................................................................................32
9. Making the hand-held transmitter operational..............................................................33
10. Pre-settings ................................................................................................................34
11. Operating with hand-held transmitter ..........................................................................35
12. Operating with timer (optional) ....................................................................................37
13. Circuit diagram for vehicles with IHR (integrated heating control) to 9.98 ....................39
14. Circuit diagram for vehicles with IHKA (automatic heating and air conditioning)
from start of production and vehicles with IHR from 9.98............................................41
Retrofit/Installation Kit no. 82 30 0 020 941 Date: 05.2000
Installation Instructions no. 01 29 0 021 305

General notes
In the course of further development it may happen that connections and/or pin assignments
change.
The current test instructions should always be used for installation purposes.
Should specified pin spaces be assigned, bridges, double crimping or parallel connections
will have to be made.
Install all electrical cables in such a way as to exclude any possibility of them sagging or
chafing.
Take care to see when installing electrical cables in the vehicle that they are not kinked
or damaged, as otherwise faults may occur which can only be eliminated by extensive
re-working.
Costs arising in this way will not be reimbursed by BMW.
Only vehicles from 9.98 with automatic air conditioning (IHKA) will have to have the IHKA
control unit and the control unit of the supplementary heater re-coded (see also p. 10).
In vehicles with heating system (IHR) no coding should be carried out.
Notes on ordering
The blower relay was gradually replaced in the series in vehicles with optional equipment
IHKA (automatic heating and air conditioning) (OE 534) to 9.98 with a plug connector and the
blower controller was modified. In vehicles with blower relay, the current state-of-the-art has to
be created (see also Chapter 4 on page 5).The parts required for this are not included in the
installation kit and have to be ordered separately.
Blower controller Part no. 64 11 8 385 549
Plug-in package Part no. 61 13 1 383 516
Plug connector (gold yellow) Part no. 61 36 8 366 282
To avoid problems of starting as a result of operating the retrofitted park heating,
it is important that you observe the following:
While the park heating is in operation the battery is discharging.To avoid problems of starting
as a result of using park heating, you should cover a distance of min.20 km per park-
heating operation,independent of howlong the park heating has been switched on
in order to ensure that the battery is adequately charged.
In vehicles with optional equipment climatic window (OE 358), the range of the remote
control is to some extent reduced.
The park heating may not be operated (even with a timer or by remote control) in enclosed
spaces such as garages or workshops without an exhaust-gas extraction system in operation!
The park heating must be switched off at service stations and/or refuelling plants.
!
!
!
EN/23
Retrofit/Installation Kit no. 82 30 0 020 941 Date: 05.2000
Installation Instructions no. 01 29 0 021 305

1. Preparatory work
TIS AW no.
Carry out short test
Disconnect battery 12 00 ...
Completely dismantle glove box 51 16 360 + 51 45 0301)
Dismantle A-pillar trim panel on right 51 43 201
Dismantle sun visor on right 51 16 080
Unclip heater/air conditioner operating unit 64 11 749 / 64 11 750
1) In thisTIS operation, only the relevant work steps for this disassembly must be carried out.
Retrofit/Installation Kit no. 82 30 0 020 941 Date: 05.2000
Installation Instructions no. 01 29 0 021 305 EN/24