Well HTR-QRZ-PW2000-WL User manual
INSTRUCTION MANUAL
ELECTRIC PATIO HEATER
Thank you for choosing WELL. Please read carefully the following instructions and keep them within reach.
Reorder No: HTR-QRZ-PW2000-WL
SAFETY WARNINGS
1. Read all instruction before using the heater.
2. Only connect the heater to a single-phase socket with a mains voltage as specified on the rating plate.
3. Do not leave your home while the appliance is in function: ensure that the switch is in OFF (0) position and
the thermostat is in minimum position. Always unplug the appliance.
4. Keep combustible material such as furniture, cushions, bedding, paper, clothes, curtains etc. at least 100cm
away from the heater.
5. Do not hand anything on or in front of the heater.
6. Always use the heater in an upright position.
7. Do not place the heater against walls, furniture, curtains, etc.
8. Do not use the appliance in rooms less than 4m² area.
9. Always unplug the heater when not in use. Do not pull the cord to unplug the heater.
10. Keep the air inlet and outlet free from objects at least 1m in front and 50cm behind the heater.
11. Do not install the heater immediately below a socket outlet.
12. Do not let animals or children touch or play with the fan heater. Pay attention the air outlet gets hot during
operation.
13. Do not cover. If covered, there is the risk of overheating.
14. Do not use this heater in the vicinity of showers, bath tubs, wash basins or a swimming pool etc.
15. Do not use the heater in the rooms containing explosive gas inflammable solvents, varnish or glue.
16. Keep the heater clean. Do not allow any objects to enter any ventilation or exhaust opening as this may cause
electric shock, or fire or damage to the heater.
17. If the heater has been dropped or damaged it should not be used until it has been inspected by a qualified
service center.
18. Close supervision is necessary when the heater is being used by or near children, persons suffering from any
physical impairment or pets.
19. Do not use to dry clothes or any fabric.
20. Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger of overheating).
21. Do not move the appliance while it is functioning in order to avoid overheating with the additional risk of
fire.
22. If any part of the heater or supply cord becomes damaged, it must be replaced by a qualified electrician. In
order to avoid a hazard.
23. Do not use this heater with a programmer, timer or any other device that switches the heater on automatically,
since a fire risk exists if the heater is covered or positioned incorrectly.
24. Do not leave the heater switched on when leaving your home or going to sleep.
25. Children should be supervised to ensure that they do not play with the appliance.
26. This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience or knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
27. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
28. Children of less than 3 years should be kept away unless continuously supervised.
29. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has
been placed or installed in its intended normal operating position and they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
30. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform
user maintenance.
Caution
Some parts of the heater can become very hot and cause burns. Do not touch hot surfaces.
Particular attention has to be given where children and vulnerable people are present.
This appliance is designed for using in garden.
Voltage
Before using the appliance at the first time, ensure that your mains voltage corresponds to voltage indicated on the
appliance. It is a class I appliance and must be earthed.
Parts list
Prior to assembly, read instructions carefully and check all the parts against part list.
This product MUST NOT being used if power cable is damaged. If there is damage, it must be replaced by
manufacturer, its service agent or similar qualified persons in order to avoid hazard.
For ease of assembly only loosely tighten bolts and then tighten fully when assembly is complete.
WARNING! DO NOT over tightening bolts; only tighten with moderate pressure to avoid damaging bolts or
components of the heater.
ASSEMBLY DIAGRAM
Wall assembly instructions
1. Mark the hole positions using a pencil and drill 4 holes into a suitably strong exterior wall by positioning the
wall bracket (2) a minimum 2m above the ground. Ensure the holes are straight by using a spirit level (not
included). Using an impact drill (not included), bore the holes in the positions you have just marked.
2. Insert 4x universal wall plugs (C) into the drilled holes. Insert 4x screws (B) into the wall plugs leaving heads
outside. Attach the bracket to the heater (1) using 3x screws (A) inserting these into the threaded holes on the
back of unit.
3. Hang the bracket onto the 4 screws in the wall.
Operation
Before plugging the heater into a power supply, please first adjust the angle of the heater.
You can change the angle of your heater by up to 45⁰. You can adjust this by moving the heater (1) to your desired
angle. Please only change the angle of your heater when it is NOT in use and it is completely cool.
To operate, ensure the heater is plugged into the correct electrical socket outlet.
Pull down the switch cord to turn the unit ON.
Controlling the heat output of the unit please use the dial as indicated in the below diagram.
The unit if OFF when “0” is selected, low power when “1” is selected, medium power “2” is selected and high power
when “3” is selected.
1 (1x)
2 (1x)
CLEANING AND MAINTENANCE
Before cleaning always remove the plug from the electrical socket outlet.
Clean the air inlet and outlet grilles frequently.
Never use abrasive powders or solvents.
SPECIFICATIONS
Voltage: 230V 50Hz
Maximum power: 2000W
3 heating power: 650/1350/2000W
Heating element: Quartz
Adjustable angle: 0-45°
Pull chain control
Power cord length: 1.9m
IP rating: IPX4
Wall mounted
Waste electrical and electronic equipment are a special waste category, collection,
storage, transport, treatment and recycling are important because they can avoid
environmental pollution and are harmful to health. Submitting waste electrical and
electronic equipment to special collection centers makes the waste to be recycled
properly and protecting the environment. Do not forget! Each electric appliance that
arrives at the landfill, the field, pollutes the environment!
Importer & distributor:
SC VITACOM ELECTRONICS SRL
CIF: RO 214527
Tel. 0264-438401*
Table of contents
Other Well Patio Heater manuals
