Wenger StageTek Chair Stop User manual

Assembly Instructions
tageTek™Chair top
©Wenger Corporation 2013 Printed in USA 04/13 Part #281A516-03
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, innesota 55060-0448
Questions? Call.....USA: 800-4WENGER (493-6437) • Worldwide: 1-507-455-4100 • www.wengercorp.com
Note: Please read and understand the instructions before starting the assembly or installation.
Note: If you need additional information, contact Wenger Corporation using the information below.
Visit the StageTek web page at www.wengercorp.com for detailed instructions and videos.
Basic Instructions only!
For Replacement Parts and more detailed product information,
refer to the tageTek™Owner’s Manual 280A099.
ATTACHING A PERMANENT CHAIR TOP
To attach a Permanent Chair Stop to the stage deck:
1. Align the Chair Stop to fit against the edge of the stage deck.
2. Attach the Chair Stop to the stage deck using #8-15 x 1-1/2” Truss Head Screws through
each of the predrilled holes in the Chair Stop and into the deck surface.
#8-15 x 1-1/2”
Truss Head crews
Permanent
Chair top
Make sure anyone assembling
or installing the StageTek
component has read and
understands the instructions.
!CAUTION
Always comply with Warnings
or Cautions in the instructions
or posted on the equipment.
!CAUTION

AEMBLING A REMOVABLE CHAIR TOP
To assemble the Removable Chair Stop:
1. Attach a Flat Plate to both ends of the Chair Stop Tube using a 3/8-16 x 1-1/2” Carriage Bolt
and 3/8-16 Jam Lock Nut in each as shown.
2
Chair
top Tube
Flat
Plate
3/8-16 x 1-1/2”
Carriage Bolt
3/8-16
Jam Lock Nut
Flat
Plate
3/8-16 x 1-1/2”
Carriage Bolt
3/8-16
Jam Lock Nut
2. Hook the tabbed-end of a Connect Bracket into the slot in each of the Flat Plates as shown.
3. Secure both Connect Brackets in place using a 3/8-16 x 3” Carriage Bolt and
3/8-16 Wing Nut in each as shown.
Connect
Bracket
3/8-16 x 3”
Carriage Bolt
3/8-16
Wing Nut
Connect
Bracket
3/8-16 x 3”
Carriage Bolt
3/8-16
Wing Nut
Tabbed-End
of
Connect Bracket

3
ATTACHING A REMOVABLE CHAIR TOP
To attach a Removable Chair Stop to the stage deck:
1. Fit the Connect Brackets under the lip of the stage deck.
It may be neccesary to loosen the Wing Nuts.
2. Position the Chair Stop Tube to fit against the edge of the stage deck.
3. Tighten the Wing Nut to fit the Connect Brackets snug to the underside of the stage deck lip.

4
This page is intentionally blank.