Wenger GearBoss Garment Bar Accessory User manual

Owner’s Manual
GearBoss Garment Bar
Accessory
©Wenger Corporation 2008 Printed in USA 02/08 Part #241A346-01
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnesota 55060-0448
Questions? Call.....USA: [phone] • International (call collect): [phone] • www.wengercorp.com
Note: Please read and understand the GearBoss Garment Bar Accessory Owner’s Manual before
attempting installation, assembly, or use.
Note: Remove all items from the shipping containers and sort the components by type, size, etc.
Refer to the illustrations on the following pages. If you need additional information about your
GearBoss Garment Bar Accessory, contact the Wenger Corporation using the information
listed below.
SAFETY
Throughout this manual you will find Cautions which are defined as follows.
• Caution; failure to follow the instruction may result in injury or damage to property.
Read and understand the following instructions before using or installing any GearBoss Accessory.
The GearBoss Garment Bar Accessory is guaranteed free of defects in materials and workmanship for five full
years.
Our guarantee assures you of either a full refund or repair or replacement of the defective materials or
workmanship without charge, at the discretion of our Customer Service Department. Just call a Customer
Service Representative at 1-800-887-7145 and state the reason you are dissatisfied. If a product return is
necessary, your representative will issue a return authorization. This is your sole remedy for breach of this
warranty.
Should you have a question or problem with any Wenger product, don’t hesitate to call, even if the product is
past warranty. It’s important to us that all our customers be satisfied.
This is the sole warranty made by Wenger. Wenger disclaims all other warranties, including the warranties of
merchantability and fitness for a particular purpose, as well as all liability for incidental, consequential, special,
and indirect damage. Wenger liability for direct damages shall be limited to the amount you paid for the
product involved. Wenger reserves the right to make product changes without obligation to incorporate such
changes into products previously sold.
Some states do not allow the exclusion or limitation of damages or warranties, so the above may not apply to
you. This warranty gives you specific legal rights. You may also have other rights which vary from state to
state.
WARRANTY

Attach the Garment Bar to the GearBoss Shelving
1. Install the tube holder bracket (item 2) onto the underside of the shelf arm (item 6) by inserting the
tab into the front hole and secure the bracket by inserting a carriage bolt (item 3) through the back
hole of the shelf arm and bracket as shown using a wing nut (item 4). Do not tighten the wing nut
yet.
2. Place one end of the garment bar (item 1) through the bracket and position the other end of the bar
so that step 1 can be repeated for the other end of the shelf.
3. Tighten the wing nuts on both ends of the garment bar.
1
42
3
6
GARMENT BAR INSTALLATION
2
Maximum Load Capacity
Rating for Garment Bar is 100
lbs (45 kg).
!CAUTION
Item Qty Description
1 1 Garment Bar
2 2 Tube Holder Bracket
3 2 Carriage Bolt, 3/8 - 16 x 3/4
4 2 Wing Nut, 3/8 - 16
5 2 End Plug
PARTS LIST
5