Whalen BSKY-368036 User manual

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Date 2016-01-06 Rev. 1 Factory: DONYUH
Big Sky Counter Height Table
Model # BSKY-368036
ADULT ASSEMBLY REQUIRED
If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the
store where it was purchased. Please call our customer service number and have your instructions and
parts list ready to provide the model name, part name or factory number:
1-866-942-5362
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday - Friday
Or visit our web site 24 hours a day, 7 days a week for product assistance at
www.whalenfurniture.com
Or e-mail your request to [e-mail]
LOT NUMBER:
DATE PURCHASED: / /

2
MANUFACTURER: Whalen Furniture Manufacturing
CATALOG: Big Sky Counter Height Table (BSKY-368036)
MADE IN CHINA
1. Please read the Assembly Instructions prior to assembling the unit.
2. To avoid damage, assemble the unit on a sturdy, level and non-abrasive surface.
3. Keep all hardware and parts out of the reach of children.
4. Please wait until all steps are completed before fully tightening bolts.
5. Make sure all bolts and screws are tightly fastened before the unit is used.
6. Check that all bolts, screws and knobs are tight at least every 3 months or as needed.
GENERAL INFORMATION, TIPS & TRICKS
MAXIMUM RECOMMENDED WEIGHT LOADS
THIS UNIT IS INTENDED ONLY FOR USE WITHIN THE MAXIMUM
WEIGHTS INDICATED. USE WITH LOAD HEAVIER THAN THE MAXIMUM WEIGHTS
INDICATED MAY RESULT IN INSTABILITY, CAUSING POSSIBLE INJURY.
MAXIMUM LOAD 100 lb. (45.3 kg)
MAXIMUM LOAD 400 lb. (181.4 kg)

3
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
A - Table Top (Qty. 1)
B - Top Support Frame (Qty. 1) C - Bottom Shelf (Qty. 1)
D - Leg (Qty. 2) E - Mounting Board (Qty. 2)
(1) 5/16-18 UNC-2A x 2” lg. Bolt (2) Lock Washer (3) Flat Washer
( Qty. 28+1 extra) ( Qty. 28+1 extra) ( Qty. 28+1 extra)
(4) M10 x 30 mm Wood Dowel Allen Wrench Touch-up Pen
( Qty. 4+1 extra) (Qty. 1) ( Qty. 1)
Tools required: Allen wrench (provided).

4
Assembly Instructions
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. Attach one Leg (D) to the corner blocks of the Top Support Frame (B) by inserting four 2'' Bolts (1) with
Lock Washers (2) and Flat Washers (3) through the drilled holes on the corner blocks and screw into the
threaded inserts on the Leg (D).
3. Insert two Wood Dowels (4) into the end holes on the Bottom Shelf (C) as a guide. Fasten the Bottom
Shelf (C) to the Leg (D) by using two 2'' Bolts (1) and two Washers (2 and 3).
4. Repeat the same procedure to attach the other Leg (D) at the opposite end.
123
4
D
C
1
23
D
D
B
C
DO NOT fully-tighten the bolts or nuts initially until all the bolts or nuts are
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.

5
Assembly Instructions
5. Stand the assembled base upright.
6. Fasten two Mounting Boards (E) to the top of Legs (D) by inserting four 2'' Bolts (1) with the Washers (2
and 3) through the countersunk holes and securely screw into place.
1
2
3
E
D
D
1
2
3
E

6
Assembly Instructions
7. Place the Table Top (A) upside down on a level and protective surface as shown.
8. Flip around the assembled base and attach the Mounting Boards (E) to the slide supports with eight 2''
Bolts (1) and eight Washers (2 and 3). Securely tighten all the bolts with the provided Allen wrench.
E
D
E
D
1
2
3
1
2
3
A

7
Assembly Instructions
9. Ask for assistance to lift the unit upright and position it at the desired location. If necessary, adjust the
pre-attached Floor Levelers at the bottom of Legs (D) to level the unit.
10. Press the button to release the locking pin on lock mechanisms underneath the Table Top (A), then pull
the Table Top wide open equally from both ends.
11. Lift both butterfly leaves from the compartment of Table Top (A).
12. Rest the leaves on one slide support and then unfold the leaf aprons.
13. Unfold the leaf and rest the top flap onto the other slide support.
14. Push the Table Top (A) from both ends to close and push up the lock ing pin into the Table Top.
1

8
To Store the Butterfly Leaf When Not In Use
15. Press the button to release the locking pin on lock mechanisms underneath the Table Top (A), then pull
the Table Top wide open equally from both ends.
16. Fold two butterfly leaves together and flip down the leaf aprons.
17. Rotate the butterfly leaves and rest them onto the leaf supports.
18. Push the Table Top (A) from both ends to close and push up the lock ing pin into the Table Top.
1

9
Care and Maintenance
 Use a soft, clean cloth that will not scratch the surface when dusting.
 Use of furniture polish is not necessary. Should you choose to use polish, test first in an inconspicuous area.
 Using solvents of any kind on your furniture may damage the finish.
 Never use water to clean your furniture as it may cause damage to the finish.
 Always use coasters under beverage glasses and flowerpots.
 Liquid spills should be removed immediately. Using a soft clean cloth, blot the spill gently. Avoid rubbing.
 Always use protective pads under hot dishes and plates. Heat can cause chemical changes that may create
spotting within the furniture finish.
 In the event that your furniture is stained or otherwise damaged during use, we recommend that you call a
professional to repair your furniture.
 Check bolts/screws periodically and tighten them if necessary.
Further advice about wood furniture care
It is best to keep your furniture in a climate-controlled environment. Extreme temperature and humidity
changes can cause fading, warping, shrinking and splitting of wood. It is advised to keep furniture away from
direct sunlight as sun may damage the finish.
Proper care and cleaning at home will extend the life of your purchase. Following these important and helpful
tips will enhance your furniture as it ages.
A Touch-up Pen has been provided to repair any small nicks or scratches that may occur during assembly or
shipping.
We hope you enjoy your purchase for many years.
Thank you for your purchase!
QUALITY GUARANTEE
We are confident that you will be delighted with your Whalen Furniture purchase.
Should this product be defective in workmanship or materials or fail under normal use, we will repair or
replace it for up to one (1) year from date of purchase. Every Whalen Furniture product is designed to meet
your highest expectations. We guarantee that you will immediately see the value of our fine furniture.
This warranty gives you specific legal rights and you may also have other rights which vary from province to
province (state to state).
Customer Service: 1-866-942-5362
8:30 a.m. - 4:30 p.m., PST, Monday to Friday
www.whalenfurniture.com