Widex otopod proglink User manual

1
OTOPOd® PrOgLink™
Quick Guide

2
COnTenTs
WHATISTHEPROGLINK™? . . . . . . . . . . . . . . . . . . . . . . . . . . . 
WIRELESSFITTINGWITHTHEPROGLINK™ . . . . . . . . . . . . . . . . . . 
USINGTHEPROGLINKWITHCOMPASS . . . . . . . . . . . . . . . . . . . 
DETECTINGTHEHEARINGAIDS . . . . . . . . . . . . . . . . . . . . . . . . . 
WHICHHEARINGAIDSCANBEPROGRAMMED
WIRELESSLYWITHTHEOTOPODANDPROGLINK? . . . . . . . . . . . . . 
WARNINGS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 
PROGLINKTROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . 
REGULATORYINFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . 
FEDERALCOMMUNICATIONSCOMMISSIONAND
INDUSTRYCANADASTATEMENT . . . . . . . . . . . . . . . . . . . . . . . . 
SYMBOLS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CONTENTS OF THE OTOPOD PROGLINK PACKAGE
OTOPod ProgLink
Fixture for in-the-ear (ITE) hearing
instruments

3
WHAT is THe PROGLiNk™?
ProgLink is a wireless adapter for programming Widex hearing aids that is
used with Otovation’s OTOPod M2 diagnostic audiometer.
The ProgLink can be connected to an existing OTOPod M2 and used with
Compass to perform a wireless fitting of CLEAR™ and future wireless hear-
ing aids from Widex.
WIRELESS FITTING WITH THE PROGLINK™
The ProgLink was developed to make wireless programming of Widex
hearing aids available for OTOPod users. The ProgLink is plugged into
the OTOPod’s programming ports, and connects with Compass™ so that
Widex hearing aids can be programmed without the need for hearing aid
cables.
Connecting the ProgLink adapter to the OTOPod
• If necessary, remove the neck string from the plastic clip on each side
of the OTOPod
• Grasp the ProgLink plug and carefully insert it into the top end of
the OTOPod where the left and right hearing aid programming cable
connectors are located.

4
Using THe PrOgLink
WiTH cOMPASS
First, insert fresh batteries in the hearing aids and turn on the hearing aids.
Use the Compass manual to assist in identifying the hearing aids.
The OTOPod and the ProgLinkTM are handled in the same manner as all
other programming units. Please read the Compass manual for further
information regarding setup.
DETECTING THE HEARING AIDS
Place the OTOPod with the ProgLink attached on the table, and place the
hearing aids inside the neck loop close to the small black box (as illus-
trated).
Please read the Compass manual for further information regarding setup.

5
Make sure that the ProgLink unit is positioned correctly, as in the illustra-
tion below.
WHICH HEARING AIDS CAN BE PROGRAMMED WIRELESSLY WITH THE
OTOPOD AND PROGLINK?
All Widex wireless hearing aids with can be fitted wirelessly with the OTO-
Pod with ProgLink. Use Compass 5.3 or a later version.
The OTOPod also supports fitting with cables with models for which cable
fitting is an option. Connect the usual cables to the OTOPod (after remov-
ing the ProgLink) to perform the programming of these hearing aids.

6
WArnings
• Keep the ProgLink and its parts and accessories out of reach of children
and anyone else who might swallow such items or otherwise cause injury
to themselves.
• Do not expose the ProgLink to extreme temperatures or high humidity.
• Do not immerse it in water
• Never try to open or repair the ProgLink.
• ProgLink parts can be dangerous if used improperly.
• Do not disconnect the ProgLink during use.
• Do not use defective units together with hearing aids.
• Do not use the ProgLink on aircraft.
• Do not use the ProgLink in mines or other areas with explosive gases.
• Do not carry the ProgLink with you during X-rays, MRIs and other scans or
radiation treatments and never place the ProgLink in a microwave oven.
These are some of the types of radiation that can damage the ProgLink.
• Radiation from room surveillance equipment, burglar alarms, mobile
phones and similar sources is weaker and will not damage the ProgLink.
However, on occasion radiation from devices such as certain burglar
alarms, automatic motion detectors and other electronics may cause
noticeable audible interference during use.
• Although the ProgLink has been designed to comply with the most strin-
gent international electromagnetic compatibility standards, the possibility
cannot be excluded that it may cause interference with other equipment,
such as medical devices.
• Clean the ProgLink with a soft cloth. Never clean the ProgLink with acids,
alcohol, strong detergents or other liquids.
• Never use any liquids near the ProgLink

7
PrOgLink TROuBLeSHOOTiNG
Problem Possible Cause Solution
Wireless program-
ming is not working
The hearing aids are not
within the ProgLink range.
Reposition the ProgLink
so that the unit is in close
proximity to the hearing
aids.
The hearing aids are not
detected by Compass.
Detect the hearing aids
by placing them in the
middle of the neck loop on
the table. Ensure that the
hearing aids are turned on.
The hearing aids are not
working.
Insert fresh batteries in the
hearing aids and turn on
the hearing aids.
ProgLink not securely
plugged into OTOPod
Check that the ProgLink is
plugged correctly into the
OTOPod.
OTOPod battery low Recharge or replace
OTOPod batteries.
OTOPod Firmware must be
updated
Contact your authorized
representative to perform
this.

8
regULATOrY iNFORMATiON
FCC ID: TTY-PROGL
IC: 5676B-PROGL
Federal Communications Commission Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV technician for help.
NOTE:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled envi-
ronment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Changes or modifications to the equipment not expressly approved by Widex could void the
user’s authority to operate the equipment.
Industry Canada Statement / Déclaration d’industrie Canada
Under Industry Canada regulations, this radio transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that nec-
essary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is sub-
ject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.

9
Electrical and electronic equipment (EEE) contains materials, com-
ponents and substances that can be hazardous and present a risk
to human health and the environment when waste electrical and
electronic equipment (WEEE) is not handled correctly.
Do not dispose of hearing aids, hearing aid accessories and batteries with
ordinary household waste.
Hearing aids, batteries and hearing aid accessories should be disposed of at
sites intended for waste electrical and electronic equipment, or given to your
hearing care professional for safe disposal. Proper disposal helps to protect
human health and the environment.
Widex A/S declares that the ProgLink is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
A copy of the Declaration of Conformity can be found at:
http://www.widex.com/doc
Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonc-
tionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour
l’émetteur par Industrie Canada.
Dans le but de réduire les risques de brouillage radioélectrique à l’intention des autres utilisa-
teurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une communica-
tion satisfaisante.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.

10
2
SYMBOLS
Symbols commonly used by Widex A/S in medical device labelling (labels/IFU/etc.)
Symbol Title/Description
Manufacturer
The product is produced by the manufacturer whose name and address are
stated next to the symbol. If appropriate, the date of manufacture may also be
stated.
Date of manufacture
The date when the product was manufactured.
Use-by date
The date after which the product is not to be used.
Batch code
The product’s batch code (lot or batch identification).
Catalogue number
The product’s catalogue (item) number.
Serial number
The product’s serial number.*
Keep away from sunlight
The product must be protected from light sources and/or
The product must be kept away from heat
Keep dry
The product must be protected from moisture and/or
The product must be kept away from rain
Lower limit of temperature
The lowest temperature to which the product can be safely exposed.
Upper limit of temperature
The highest temperature to which the product can be safely exposed.
sYMBOLs

11
3
Symbol Title/Description
Temperature limits
The highest and lowest temperatures to which the product can be safely exposed.
Consult instructions for use
The user instructions contain important cautionary information
(warnings/precautions) and must be read before using the product.
Caution/Warning
Text marked with a caution/warning symbol must be read before using
the product.
WEEE mark
“Not for general waste”
When the product is to be discarded, it must be sent to a designated collection
point for recycling and recovery.
CE mark
The product is in conformity with the requirements set out in European
CE marking directives.
Alert
The product is identified by R&TTE Directive 1999/5/EC as an equipment Class
2 product with some restrictions on use in some CE member states.
C-Tick mark
The product complies with EMC and radio spectrum regulatory requirements for
products supplied to the Australian or New Zealand market.
Interference
Electromagnetic interference may occur in the vicinity of the product.
*The six- or seven-digit number on the product is the serial number. Serial numbers may not
always be preceded by

12
WIDEX A/S Nymoellevej 6, DK-3540 Lynge, Denmark, www.widex.com
É[5pw2e2|d;;a;j]
Manual no.:
9 502 2323 001 #03