Wideye iFleetONE User manual

Ver : 2.0
Date : 26 August 2021
Quick Start Guide
Satellite Terminal

iFleetONE Antenna Unit
iFleetONE Modem Unit
Figure 1: iFleetONE ADU
1
1. Radome Top
2. Radome Bottom
3. Antenna Connector (N-Type)
1. Antenna Connector (N-Type) 7. LAN Port
2. Wi-Fi Antenna 8. RJ11 Port
3. I/O Port 9. SIM Card Slot
4. GPS Output Port 10. Primary Handset Port
5. Status LEDs 11. Circuit Breaker Reset
6. ON / OFF Switch 12. DC Input
3
2
10
9
8
7
6
5
4
3
2
1
11
12

iFleetONE Terminal Simplied Block Diagram
Above Deck Unit (ADU) Installation
Refer to Installation Manual for more detailed information on the mounting of ADU.
Connect coaxial cable to ADU properly without
kinking it, before installing it on the pole mount or
mast’s mounting surface
1
Secure ADU to the pole mount or mast by using M6
x 20mm screws and at washers.
2
With WIFI:
+24V/+12V DC

Below Deck Unit (BDU) Installation
Secure the right and left mounting bracket
using M5 x 12mm Self-Tapping Screws (2x).
Connect and secure DC power cable, antenna
cable and primary handset cable to the BDU’s front
panel
Place BDU onto the desired installation area.

BDU LED StatesGetting Started
• Connect the cables and accessories as shown
in Terminal Simplied Block Diagram.
• Insert a Fleet One SIM card, with the gold
printed circuit facing down.
• Switch on the terminal.
• User can access the web console when the
Terminal LED turns green.
• System is ready for normal operation when
the Terminal, Antenna and Registered LEDs
turn green.
Using the Optional Primary Handset
• On the optional primary handset, dial phone
number in the format:
<00><CountryCode><Telephone Number>
• Disconnect the call by pressing the key.
Using a Corded Analog Telephone
• Lift the handset or press the o󰀨-hook button,
listen for the dial-tone and dial phone number in
the following format:
<00><Country Code><Telephone Number><#>.
• Hang-up to disconnect.
Sending an SMS using the Optional
Primary Handset
• Select Menu>Messaging>OK>New
message>OK. Enter your test message using
the keypad.
• Select OK > Send.
• Enter the destination mobile number format:
<00><Country Code><Telephone Number>
OR
Select OK to choose an existing contact and
then select OK to send text message.
Status Meaning
TERMINAL
Steady Amber Terminal (BDU) is powering up.
Steady Green Terminal (BDU) has powered up
successfully.
Steady Red Terminal (BDU) has detected a
failure state.
Blinking Red VMS Alarm Notication.
ANTENNA
Steady Amber ADU is powering up.
Steady Red ADU has detected a failure
state.
Blinking Amber ADU is calibrating.
Blinking Green System is performing satellite
search.
Steady Green System has locked onto satellite.
No light (O󰀨) ADU is in OFF state.
REGISTERED
Steady Amber Attempting network registration
Steady Green Ready for all (Voice and Data).
Steady Red Network failure / Registration
error.
Blinking Amber Ready for Voice only.
Blinking Green Ready for Data only.
No light (O󰀨) No network service.
DATA ACTIVE
Steady Amber Activating data connection.
Steady Green Data connection is ready.
Steady Red Data activation failure
No light (O󰀨) No data connection.
Useful Password Reference:
• Web Console Username: admin (Default)
• Web Console Password: 1234 (Default)
• Terminal Pin: 0000 (Default)
Also applies to Factory Reset password.

Deactivating / Activating a Data Session with the Web Console
On the Web Console, click on the “Home” icon. • Click on the “Activate Data Connection” icon.
Standard Data Session is now active and user
can access the Internet.
• To disconnect Data Session, click on
“Deactivate Data Connection”.
1 2
Accessing Web Console
31
Open the web browser, type http://192.168.1.35 in
the Address eld.
2
Type in admin in Username eld and 1234 in
Password eld. Click Login.
The terminal will automatically acquire the GPS
location and register to the network. This would
take 1.5 to 2 minutes.

Accessing VMS Forms / Declarations:
1
2
Tips and Troubleshooting
Primary Handset
Unable to make outgoing call
• Ensure a correct number format is being dialled.
• Ensure proper BDU LED states;
Terminal : Green
Antenna : Green
Registered : Green
Data Active : O󰀨 or Green
Unable to receive incoming call
• Ensure all other telephony devices are hung up
properly.
Web Console
Unable to access Web Console
• Ensure that there is no problem with the Ethernet
connectivity.
• Ensure that IP address is entered correctly.
• Try to refresh the browser after correcting the
problem.
Data Connection
Unable to activate Data Session
• Ensure you are using a valid APN.
• Ensure that the signal strength is good.
• Ensure your Fleet One SIM card supports PS
services.
• Ensure your prepaid credit is not exhausted.
Unable to access internet after Data Session is
activated.
• Ensure proper PC/Laptop Ethernet settings.
• Ensure no rewall/proxy settings are preventing
access to the BDU.
• Ensure that PC/Laptop is congured to obtain
IP address automatically (DHCP).

P/N : 74B00001003 Revision 2.0
Whilst the information in this User Manual has been prepared by Addvalue Innovation Pte Ltd (“Addvalue”) in good faith, and all
reasonable e󰀨orts have been made to ensure its accuracy, Addvalue makes no warranty or representation as to the accuracy,
completeness, or tness for purpose or use of the information. Addvalue shall not be liable for any loss or damage of any kind,
including indirect or consequential loss, arising from use of the information and all warranties and conditions, whether express
or implied by statute, common law or otherwise, are hereby excluded to the extent permitted by the law of Singapore. Addvalue, the
Addvalue Enabled logo, Wideye, Wideye logo, IFleetONE, iFleetONE logo are either trademarks or registered trademarks of
Addvalue Technologies Ltd and/or its a󰀩liates in Singapore and/or other countries. Inmarsat, the Inmarsat logo registered trademarks
of Inmarsat Global Limited in the United Kingdom and/or other countries, and are used by Addvalue Innovation Pte Ltd under license.