Wildridge heritage LCC-114 User manual

ASSEMBLY INSTRUCTIONS
heritage
adirondack chair
330-893-4212 • www.wildridge.com
LCC114
© 2017
Required Tools:
- 7/16”Wrench or Socket
- Mallet/Non-Marring Hammer
(DO NOT Use Metal Headed
Hammer)
- #2 Square Drive Bit
- Cordless Drill
Hardware:
- (8) 1/4” x 2 1/4” Bolts
- (10) 1/4” Flange Nuts
- (4) 2” Screws
- (2) 1/4” x 2 3/4” Bolts
- (8) 1 1/4” screws
Parts:
A: Back
B: Seat
C: Legs
D: Brace
E: Left Armrest
F: Right Armrest
Step 1
Place the seat on a level surface. Fasten the back (A) onto the seat
(B) using (4) 1/4” x 2 1/4” bolts (2 on each side) and (4) 1/4” ange
nuts (2 on each side) thru the pre-drilled holes.
A
B
Step 2
Place one of the legs (C) with the bracket support up and facing
outward, as shown onto the side of the front of the seat. Fasten
together with (2) 1/4” x 2 1/4” bolts and (2) 1/4” ange nuts. Repeat
on other side.
C
D
E
A
B
C
F

ASSEMBLY INSTRUCTIONS
heritage
adirondack chair
330-893-4212 • www.wildridge.com
LCC114
© 2017
Step 3
Using (2) 2” screws, attach the brace (D) to the legs. Repeat on the
other side.
Step 4
Attach the left armrest (E) to the back of the left side of the chair (as
pictured) with (1) 1/4” x 2 3/4” bolts and (1) 1/4” ange nut. Repeat
on the right side with the right arm rest (F).
Step 5
On the front of the armrest measure a 3/4” overhang on the inside
as shown, fasten the armrest using (4) 1 1/4”screws. Repeat on the
other armrest.
Step 6
Your chair is complete.... enjoy!
Thank you for purchasing from Wildridge.