Wildridge LCC-203 User manual

Assembly Instructions
© 2017
LCC-203 Savannah Swing
A
www.wildridge.com
330-893-4212
Required Tools:
- Hammer
- Cordless Drill
- #2 Square Drive Bit
- 1/2” and 7/16” Wrench or
Socket
Hardware:
- Swing Chains
- (4) 5/16” Nylon Lock Nuts
- (3) 1/4” x 3” Lag Bolts
- (4) Connector Links
- (4) 1/4” x 3 1/2” Carriage
Bolts
- (4) 1/4” Nylon Lock Nuts
- (7) 1/4” Washers
- (4) 2” Screws
- (2) 5/16” x 4” Eye Bolts
- (2) 5/16” x 5” Eye Bolts
- (4) 5/16” Flange Nuts
- (4) 5/16” Washers
Step 1
Mount back (A) onto seat (B) with (3) 1/4" x 3" lag
bolts and washers. Insert lag bolts through pre-drilled
holes in back keeping ush with back of seat supports
as shown. Do not tighten all the way until step 3 is
complete.
Step 2
Attach arm rests with (4) 1/4" x 3 1/2" bolts, washers
and nylon lock nuts on sides. Also fasten front boards
with (4) 2" screws as shown. NOTE: left and right.
B
C C

Assembly Instructions
© 2017
LCC-203 Savanah Swing
www.wildridge.com
330-893-4212
Step 3
Now thread a ange nut on all eye bolts as far as thread
allows with ange away from eye. Using the shortest
eye bolts for the front of arm and longest in back, feed
through pre-drilled holes and fasten with 5/16" washers
and 5/16" nylon lock nuts. Use the (4) connector links
to attach chain to eye bolts.
Complete