Wildridge LCC-112 User manual

ASSEMBLY INSTRUCTIONS
heritage
upright adirondack chair
330-893-4212 • www.wildridge.com
LCC112
© 2021
Required Tools:
- Mallet/Non-Marring Hammer
(DO NOT Use Metal Headed
Hammer)
- #2 Square Drive Bit
- Cordless Drill
- 7/16”Wrench or Socket
Step 1
Place the seat (A) on a level surface. Set the backrest (B) onto the
seat, making sure the back rest slides up against the stop on the
seat on both sides of the chair.
Step 3
Lay the backrest/seat on its left side. Place the right facing arm as-
sembly (C) onto the side as shown, line up the holes, and tap a
1/4” x2 1/2” bolt through each of the four holes, repeat on the
other side with the left facing arm assembly (D).
Hardware:
(4) 2 1/2” Screws
(8) 1/4” x2 1/2” Bolts
(8) 1/4” Flange Nuts
(2) 1/4” x 3” Lag Bolts
(2) 1/4”Washers
(4) 2” Screws
Parts:
A = (1) Seat
B = (1) Backrest
C = (1) Right Facing Arm Assembly
D = (1) Left Facing Arm Assembly
E = (1) Stretcher
Step 2
Fasten the back onto the seat through the two pre-drilled holes
provided, using (2) 2 1/2” screws, repeat on the other side of the
chair.
D
A
B
C
E
A
B
Slide The Backrest
Up Against
The Stop
Use (2) 2 1/2” Screws
(2) 1/4” x2 1/2”
Bolts
Note: The
narrower part
of the armrest
goes towards the
backrest.
(2) 1/4” x2 1/2”
Bolts
C

ASSEMBLY INSTRUCTIONS
heritage
upright adirondack chair
330-893-4212 • www.wildridge.com
LCC112
© 2021
Your chair is now complete.... enjoy!
Thank you for purchasing from Wildridge.
Step 4
On the underside of the chair, add a 1/4” ange nut to each of the
bolts, and tighten. Do this for both arm assemblies.
Step 5
Place a 1/4”washer onto a 1/4” x 3” lag bolt and fasten the backrest
to the arm assembly through the hole provided, repeat with the
other arm assembly.
Step 6
Slide the stretcher (E) into the slots on the inside of the front legs.
Fasten from the outside, through the holes provided with
(4) 2” screws, two per leg.
E