Wildridge Single Classic Glider LCC-206 User manual

Assembly Instructions
© 2017
LCC-206 Single Classic Glider
Step 1
Position seat (B) and back (A) as shown and fasten with
(4) 2” carriage bolts and (4) 1/4” ange nuts.
Step 2
Fasten the leg (C) in position shown using (1) 4”
carriage bolt in back of arm, and (1) 3 1/2” carriage bolt
in front leg, and (2) 1/4” ange nuts. Repeat other side.
A
Required Tools
- Hammer
- Cordless Drill
- #2 Square Drive Bit
- 9/16” & 7/16” Wrench or
Socket
Hardware
- (4) 1/4”x2” Carriage Bolts
- (2) 1/4”x4” Carriage Bolts
- (2) 1/4”x3 1/2” Carriage Bolts
- (8) 1/4” Flange Nuts
- (8) 3/8”x2 1/2” Machine Bolts
- (16) 3/8” Washers
- (8) 3/8” Lock Nuts
- (8) 3” Screws
- (4) Glider Brackets
www.wildridge.com
330-893-4212
B
D
E
C

Assembly Instructions
© 2017
LCC-206 Single Classic Glider
www.wildridge.com
330-893-4212
Step 4
Now mount glider bracket on base using (4) 3/8”x2
1/2” machine bolts, (8) 3/8” washers, and (4) 3/8” lock
nuts. First slide a washer on bolt and push through hole
provided from inside to outside. Add another washer
then hang gllider bracket with curve away from bottom,
then fasten with 3/8” lock nuts.
Step 5
Set the seat assembly over the base and fasten bottom
of glider brackets to leg assembly with (4) 3/8”x2 1/2”
machine bolts, (8) 3/8” washers, and (4) 3/8” locknuts
in same manner as step 4. Note: Upright base pieces are
straight up and down in front and on an angle in back.
Complete
Step 3
Position glider base assembly (D) and base supports (E)
as shown and fasten with (8) 3” screws through counter
sink holes provided.