Williams 96 LED Series User manual

96 & 97 LED SERIES
INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065 Page 1 of 2
PN 4909017403/16/16JL
WARNING:
• This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
• Make sure all electrical power is turned off while installing the fixture.
• This luminaire must be adequately grounded for protection against
shock hazards and to assure proper operation.
• Disconnect power before servicing.
• LEDs are ESD (Electro Static Discharge) sensitive devices that can be
easily damaged if the proper ESD mitigating steps are not taken.
• LEDs are very sensitive to mechanical damage. Caution must be taken
to avoid damage to the LEDs.
• ESD or mechanical damage voids all warranties.
FIXTURE DETAIL
Use the illustrations below when assembling or disassembling the fixture. (96, 4’ shown)
Latch
Mounting bracket
Wireway cover
Lens
F
iberglass housing
End plug
BACKVIEW
B
A
Nominal
Length
Overall
Length (A)
Mounting
Distance (B)
2’ 27-5/8” 12”- 17” OC
4’ 51-7/8” 30”- 42” OC
8’ 100-1/4” 48”- 80” OC

96 & 97 LED SERIES INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065
Page 2 of 2
PN 49090174
INSTALLATION
Step 1: Securely attach mounting brackets (2) to mounting surface.
The 96/97 enclosure will engage the mounting brackets
at any point along itslength, except for where there are
latches. Required spacing between the brackets are as
follows: 12” - 17” for 2’ housings, 30” - 42” for 4’ housings,
and 48”- 80” for 8’ housings.
Step 2: Insert one side of the 96/97 housing into the mounting
brackets.
Step 3: Push up on the enclosure and then press in on the
mounting bracket until the mounting bracket clicks into
place.
Step 4: Verify that the enclosure is fully supported before
connecting to a power supply.