Williams 96 Series User manual

96 & 97 LED SERIES
INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065
Information contained herein is subject to change without notice.
PN #49090174
Page 1 of 2
REV.12/20/23.JL
WARNING:
■This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
■Make sure all electrical power is turned off while installing the fixture.
■This luminaire must be adequately grounded for protection against
shock hazards and to assure proper operation.
■Disconnect power before servicing.
■LEDs are ESD (Electro Static Discharge) sensitive devices that can be
easily damaged if the proper ESD mitigating steps are not taken.
■LEDs are very sensitive to mechanical damage. Caution must be taken
to avoid damage to the LEDs.
■ESD or mechanical damage voids all warranties.
■Suitable for wet locations.
FIXTURE DETAIL
ENSURE THE LENS IS PROPERLY SEATED AND CENTERED IN THE GASKETED GROOVE PRIOR TO CLOSING THE LATCHES. FAILURE TO DO SO
CAN RESULT IN DAMAGING THE LENS, LEADING TO LENS FAILURES THAT ARE NOT COVERED UNDER WARRANTY.
Note: Use the illustrations below when assembling or disassembling the fixture. (96, 4′ shown)
Latch
Mounting bracket
Wireway cover
Lens
Fiberglass housin
g
End plug BACKVIEW
A
B
OVERALL
LENGTH (A)
MOUNTING
DISTANCE (B)
2′
27-5/8″ 12″- 17″ OC
4′
51-7/8″ 30″- 42″ OC
8′
100-1/4″ 48″- 80″ OC
TABLE OF CONTENTS
FIXTURE DETAIL.................................................................................................1
WIRING DIAGRAM.............................................................................................2
INSTALLATION...................................................................................................2

96 & 97 LED SERIES
INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065
Information contained herein is subject to change without notice.
PN #49090174
Page 2 of 2
REV.12/20/23.JL
WIRING DIAGRAM
Purple (DIM +)
Pink or Gray (DIM -)
0-10v Dimming driver leads.
Refer to the dimming driver
instructions, if needed.
Black (Line)
White (Neutral)
Ground
LED Driver(s)
Driver/power supply disconnects accept #12 – #16 AWG stranded or solid wire.
Attach power supply and ground wires using UL listed wire connectors.
Please consult factory for other driver configurations or emergency driver wiring diagrams.
Ground wire
if needed
Supply
INSTALLATION
Step 1: Securely attach mounting brackets (2) to mounting surface.
The 96/97 enclosure will engage the mounting brackets at
any point along itslength, except for where there are latches.
Required spacing between the brackets are as follows: 12″ - 17″
for 2′ housings, 30″ - 42″ for 4′ housings, and 48″- 80″ for 8′
housings.
FIG 1.1
Step 2: Insert one side of the 96/97 housing into the mounting
brackets.
FIG 2.1
Step 3: Push up on the enclosure and then press in on the mounting
bracket until the mounting bracket clicks into place.
FIG 3.1
Step 4: Verify that the enclosure is fully supported before connecting
to a power supply.
FIG 4.1