Wilson & Fisher GBO18-022 User manual

ALL WEATHER WICKER PAPASAN CHAIR
ASSEMBLY INSTRUCTION
ITEM# GBO18-022
SKU# 810459554
DO NOT RETURN THIS PRODUCT TO THE STORE. FOR MISSING PARTS OR QUESTIONS TO THIS PRODUCT PLEASE CALL
US AT 1-888-733-8169
OR EMAIL US AT customerservice [e-mail] OR customerservice [e-mail] OR customerservice [e-mail]
IMPORTANT :
Please read all the instructions and warnings before assembling . In order to make the whole product adjust to the best, please install all the screws on the product
before fully tighten, and note to put the washer to the screw before putting the screw into the screw hole.
WARNING:
Use the correct screws as indicated. All screws should be hand tight untill the complete piece is assembled ( This will make the assembly process much
easier ). Once the piece is fully assembled, then go back and tight all screws with provided tool.
Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area of the product construction.
Keep assembly area at leat 6 feet from any obstruction such as a fence, garage, house, overhanging branches, laundry line or electrical wires.
Some parts may contain sharp edges. When assembling and using this product, basic safety precautions should always be followed to reduce the risk of personal
injury and damage to the product. Please read all instructions before assembly and use.
The chair is not to be used for standing purposes and will not function as a stool or step-ladder. Use on even surfaces only.
The chair is not a toy. Proper use of the chair is for single person seating only. Chair tested for use at weight of 250 lb (113.4 kg). Improper use of this
product or failure to use as directed may result in injury. Not intended for commercial use.
CARE & MAINTENANCE
STAIN RESISTANT CUSHIONS CARE —— KEEP THE CUSHIONS IN STORAGE IN RAINING DAY.
SPILLS: Immediately wipe up the spill using a white damp cloth. Repeat process if necessary until stain is gone. Allow cushion to air dry.
FABRIC CARE: Hand wash cold, non-chlorine bleach when needed, lay flat to dry. Cool iron if necessary. Do not dry clean.
ALL WEAHTER WICKER PRODUCT CARE
Before using, clean the product completely with a soft dry towel. When not in use, wipe free of any dirt or loose objects, wash with a mild solution of soap and
water, rinse thoroughly and dry completely. Do not use strong detergent or abrasive cleaners. Over time nuts and screws can loosen. Occasinally, check nuts and
screws on the chair, re-tighten if necessary.

PARTS LIST
NO. Part Qty Image NO. Part Qty Image
ABottom Seat 1BTop Seat 1
CBase 1DShort Screw 4
ENut 4FWasher 8
GLong Screw 4HWrench 1
IAllen Wrench 1
STEP 1
Attach Bottom Seat (A) and Top Seat (B) by using 4
long screws (G), 8 washers (F) and 4 nuts (E) with
wrench (H) and allen wrench (I). (NOTE: Use one
washer (F) on one long screw (G) and get the long
screw (G) through each hole. Then place another
washer (F) and nut (E) on the end of this long screw
(G).
STEP 2
Attach base (C) to Bottom Seat (A) by using 4 short
screws (D) with allen wrench (I).
STEP 3
Place cushion on the seat of chair. Finished!
D
I