WilTec 62543 User manual

Operation Manual
12V Mini Pump
62543, 62544, 62545
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ
insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.

The information contained in this document is subject to change without prior notice. o part of this
document can be copied or duplicated in another form without the prior written consent of WilTec
Wildanger Technik GmbH. The WilTec Wildanger Technik GmbH assumes no liability for any errors in
this user manual or the connection diagram.
Although WilTec Wildanger Technik GmbH has made every effort to make sure that this user manual
is complete, accurate and updated, errors cannot always be avoided. In the event of problems with
this user manual please complete and send this form back to us.
FAX-notification (+++49 2403 55592-15 ,
from: ________________________________________
Name: ________________
Firm:_____________________
Tel/Fax:__________________
I would like to report the following mistakes:
_______________________________ ____________________________________
Customer Service WilTec Wildanger Technik GmbH
e-mail: [email protected]
Tel: ++49 2403 55592-0
Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our
clients take some basic safety precautions when using this device. Please read the operation
instructions carefully and make sure you have understood its content.
Keep these operation instructions safe.
© by WilTec Wildanger Technik GmbH Seite 2
http://www.WilTec.de
http://www.aoyue.eu November 2019 Version 2
http://www.teichtip.de

Product information
This pump convinces by newest technology, a stable product performance, a compact design, a light
weight and a versatile application possibility. The pump can be easily connected to a car battery.
Safety instructions
This device is not intended for use by persons (including children) with limited physical, sensory or
mental abilities or for lack of experience and/or knowledge, unless they are supervised or instructed by
a person responsible for their safety how to use this device. Children should be supervised to ensure
that they do not play with the device.
Perform a visual inspection of the appliance before each use. Do not use the device if safety
devices are damaged or worn. ever override safety devices.
Use the device only for the purpose specified in this manual.
You are responsible for safety in the work area.
If the cable or plug is damaged due to external influences, the cable must not be repaired! The
cable must be replaced with a new one. This work may only be carried out by a qualified elec-
trician.
The voltage of 230 Volt alternating voltage specified on the type plate of the device must cor-
respond to the existing mains voltage.
ever lift or transport the device by means of the mains cable.
Make sure that the electrical plug connections are located in a flood-proof area and that they
are protected from moisture.
Disconnect the device from the power supply before carrying out any maintenance or repair
work.
Do not expose the product to direct water jets or rain.
The operator is responsible for compliance with local safety and installation regulations. (Ask a
qualified electrician if necessary)
If the device should fail, repair work may only be carried out by a qualified electrician.
The unit must never run dry or be operated with the suction pipe fully closed. Any damage to
the unit caused by dry running will invalidate the manufacturer's warranty.
Warning!
Read all safety instructions and instructions. Failure to follow the safety precautions and instructions
may result in electric shock, fire and/or serious injury. Keep all safety information and instructions in a
safe place for future reference.
Commissioning
The maximum temperature of the pumped liquid should not exceed +35°C in continuous operation.
The pumping of aggressive liquids (acids, lyes, silo leach etc.) as well as liquids with abrasive sub-
stances (e.g. sand) must be avoided. Also do not pump any highly flammable liquids (e.g. petrol) with
this pump.
The oil suction pump is suitable for a clean oil change or for pumping off engine, diesel and heating oil.
© by WilTec Wildanger Technik GmbH Seite 3
http://www.WilTec.de
http://www.aoyue.eu November 2019 Version 2
http://www.teichtip.de

Attention!
Danger of explosion! Do not pump petrol, petroleum or other easily inflammable liquids!
Ensure correct polarity when connecting the battery terminals!
Always switch off the engine when vacuuming.
Always heat engine oil before vacuuming!
ever let the pump run "dry". If the oil flow stops, switch off the pump immediately.
Collect used oil in a sufficiently large container. Do not drain into the ground or sewage sys-
tem! Dispose of the waste oil in the waste oil collection point!
ote: The oil suction pump is designed for an operating time of approx. 15 minutes. Then allow the
unit to cool down.
Operating the oil suction pump
Before changing the oil, let the engine warm up until the oil temperature has reached approx. 40-60°
C.
2 Switch off the engine.
3. connect the suction probe with suction hose to the suction port and the drain hose to the discharge
port of the pump. In order to prevent the hoses from coming loose, they are fixed with the enclosed
hose clamps.
Insert the suction probe into the dipstick tube and push it to the lowest point of the oil pan.
5 Place the drain hose in a suitable container.
6. now connect the oil suction pump to the battery. Pay attention to the correct polarity (black terminal
on negative pole, red terminal on positive pole of the battery).
7. switch on the pump and vacuum it up.
8. after completion of the suction process switch off the pump again. ever let the pump "run dry".
9. fill your vehicle with new engine oil. Then check the oil level with the oil dipstick.
ote: After finishing the work, carefully clean the pump and accessories and store them in a dust-pro-
tected place.
Technical parameters:
Rated voltage: 12V maximum load current of 1.5A
Rated voltage: 24V maximum load current of 0.8A
Motor speed: 8700r/min
Traffic:12 L/min
© by WilTec Wildanger Technik GmbH Seite 4
http://www.WilTec.de
http://www.aoyue.eu November 2019 Version 2
http://www.teichtip.de

Disposal regulations
EU guidelines regarding the disposal of scrap electric appliances (WEEE, 2012/19/EU) were
implemented in the law related to electrical and electronic equipment and appliances.
All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out
wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the
domestic waste.
The company WilTec Technik GmbH has been registrated in the German registry EAR under the
WEEE-registration number DE45283704.
Disposal of used electrical and electronic appliances
(intended for use in the countries of the European
Union and other European countries with a separate
collection system for these appliances).
The logo on the article or on its packaging points out
that this article must not be treated as normal
household waste but must be disposed to a recycling
collection point for electronic and electrical waste
equipment. By contributing to the correct disposal of
this article you protect the environment and the health
of your fellow men. Environment and health are
threatened by inappropriate disposal.
Materials’ recycling helps reduce the consumption of raw materials.
Additional information on recycling this article can be provided by your local community, municipal
waste disposal facilities or the store where you purchased the article.
Address:
WilTec Wildanger Technik GmbH
Königsbenden 12 / 28
D-52249 Eschweiler
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part of this instructions
manual require the written permission of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH Seite 5
http://www.WilTec.de
http://www.aoyue.eu November 2019 Version 2
http://www.teichtip.de