wingtra WingtraOne User manual

wingtra.com
Wingtra Support
Changing from Rededge
to RGB Camera
All manuals and user guides at all-guides.com
all-guides.com

2
REQUIRED EQUIPMENT
Caution
+ Deviating from the described procedure can lead to damage on
the sensor and hence to faulty images.
+ In case of loose payloads or shifted CG it can make WingtraOne
Required Equipment
+WingtraOne
+Torx screw driver
+RGB camera and mount
+Closed Topcover
+Micro USB storage adapter with SD card (only for QX1 camera)
+PPK module (if applicable)
+ Three M3x12 torx screws
All manuals and user guides at all-guides.com

3
STEP BY STEP PROCEDURE
Step by step procedure
1 Make sure WingtraOne is not powered
2 Lay down WingtraOne on a flat surface
3 Open the topcover
4 Unplug the USB-C universal payload adapter.
5 Use the torx screw driver to open the four screws in
each corner of the payload area. (Note: the screws are
attached to the camera mount. You do not need to
worry about losing them inside)
6 Lift out the camera mount assembly
7 Insert the RGB camera mount with camera
8 Tighten the screws in all four corners using the torx
screw driver and plug in the USB-C payload adapter.
9 Install the PPK module (if applicable)
a Plug in the plug of the PPK cover to the protruding
connector
All manuals and user guides at all-guides.com

4
STEP BY STEP PROCEDURE
d If the black antenna of the PPK module is not yet
installed screw it onto the antenna connector
10 Plug in the USB-C universal payload adapter
11 Make sure to have a SD Card inside the camera or to
insert the micro USB SD card reader to the micro USB
port of WingtraOne (for QX1 camera)
QX1 RX1
12 Close the PPK cover by using the push button.
13 Take the new closed topcover and close WingtraOne
payload area.
14 Finalize WingtraOne Setup with RGB Camera
aPower on WingtraOne
bOpen WingtraPilot App and connect the telemetry
antenna to connect to WingtraOne
cCreate a new flight plan
imake sure to select the right camera when going
through the wizard
dThe RGB Camera will be detected and WingtraPilot
prompts you to repower WingtraOne to initialize the
RGB Camera correctly
b Carefully insert the white PPK module. Pay attention
to not pull out the connected cable.
c Fixate the PPK module using the three torx screws
(M3x12) with the torx screw driver.
All manuals and user guides at all-guides.com

5
STEP BY STEP PROCEDURE
For assistance or further information visit
support.wingtra.com or contact
[e-mail]
i
e Confirm by clicking “Yes”
fRepower WingtraOne to safe the new camera
This can take some time. Wait at least more
than a minute for WingtraOne to establish the
connection.
i
All manuals and user guides at all-guides.com

For a quote, a live demonstration or more information
on the Wingtra products please contact us via
www.wingtra.com/where-to-buy or [e-mail]
For assistance or further information visit support.
wingtra.com or contact [e-mail]
Wingtra AG Giesshübelstrasse 40
8045 Zürich, Switzerland
[e-mail]
wingtra.com
All manuals and user guides at all-guides.com
all-guides.com