World Market 468259 User manual

THANK YOU FOR PURCHASING OUR QUALITY PRODUCT. IF YOU HAVE ANY
QUESTIONS PERTAINING TO THE ASSEMBLY OF THIS FURNITURE PIECE,
PLEASE CONTACT YOUR NEAREST WORLD MARKET STORE, OR CALL OUR
TOLL FREE NUMBER 877-967-5362 FOR ASSISTANCE.
Everett Foyer Table
R
Assembly Instructions
SKU - 468259
NOT FOR COMMERCIAL USE.
Page 1

Page 2
Qty
Description
Picture
Label
Qty
Description
Picture
Label
Qty
Description
Picture
Label
ATable Top 1
Hardware List
Tool List
Parts List
Leg 4
C
T-1 1
Allen Key
Allen Bolt 12
H-1
Lock Washer 12
H-2
H-3 Flat Washer 12
BShelf 1
Center Leg 2
D
Size
Size
M6 x 50 mm
Ø 6 x 10.5 x 2 mm
Ø 6 x 16 x 1 mm
Anti Tip-Kit
H-4 1
4 x 57 x 25 mm

Before Beginning :
Page 3
Assembly Preparation
In case of missing parts, please contact your nearest World Market
store or our customer service call center 877-967-5362.
Assemble on a clean non-marring surface (packing foam).
Unpack all hardware bags and components to ensure you have all parts.
Read instructions, cover to cover.
Have 2 adults on hand for assembly.
Do not assemble on flooring or carpet.
Save all packaging until finished.

Step 1
Step 2
Page 4
Assembly Steps
A
H-3
H-2
H-1
T-1
3x
A
C
Position and secure 3 Legs (C) into corners using Flat Washers (H-3), Lock Washers (H-2) and Allen Bolts (H-1)
using Allen Key (T-1). Do not fully tighten Allen Bolts.
(H-1) Allen Bolt x 3
(H-2) Lock Washer x 3
(H-3) Flat Washer x 3
(T-1) Allen Key x 1
C
C
Step 1.1: Place Table Top (A) down onto a padded, non-marring surface. Pull both drawers out and press
upwards on the plastic drawer stop inside to completely remove each drawer.
Step 1.2: Using a second person to assist you, carefully turn Table Top (A) upside down as shown.
180°
Step 1.1: Step 1.2:

Step 3
Page 5
H-3
H-2
H-1
T-1
A
B
3x
H-3
H-2
H-1
T-1
2x
A
B
C
4th Leg
Install the 4th leg (C) into the assembled unit and secure with Table Top (A) and Shelf (B) using Flat Washers
(H-3), Lock Washers (H-2) and Allen Bolts (H-1). Do not fully tighten Allen Bolts.
Position Shelf (B) into notches on each installed Legs (C) and secure with Flat Washers (H-3), Lock Washers
(H-2) and Allen Bolts (H-1). Do not fully tighten Allen Bolts.
(H-1) Allen Bolt x 3
(H-2) Lock Washer x 3
(H-3) Flat Washer x 3
(T-1) Allen Key x 1
Step 4
(H-1) Allen Bolt x 2
(H-2) Lock Washer x 2
(H-3) Flat Washer x 2
(T-1) Allen Key x 1
C
C

Step 5
Step 6
Page 6
T-1H-1H-2H-3
2x
2x
B
A
D
D
Position and secure Center Legs (D) to the assembled unit and secure with Table Top (A) and Shelf (B) using
Flat Washers (H-3), Lock Washers (H-2) and Allen Bolts (H-1). Fully tighten all Allen Bolts from this and all
previous steps using Allen Key (T-1).
NOTE: Levelers can be used
for adjustment if needed.
Turn the assembled unit upright. Re-install Drawers into Table Top (A).
The table is assembled and ready for use.
(H-1) Allen Bolt x 4
(H-2) Lock Washer x 4
(H-3) Flat Washer x 4
(T-1) Allen Key x 1

Do not put hot items directly on furniture surface.
Do not clean furniture with harsh cleansers or polish.
Do not place furniture in direct sunlight.
Do not place furniture near heating or cooling vents.
Do not write on furniture without a padded barrier to protect the surface.
Do not place furniture outside. For indoor use only.
Not for commercial use. For residential use only.
Dust and pick-up spills using a clean,non-colored, lint-free cloth.
Cleaner
Care & Maintenance
Page 7

75 mm
Anti-Tip Measures
Anti-Tip kit contents Anti-Tip kit installation
Page 8
WARNING - Children may be injured by tipping furniture and the use of the Anti-Tip Kit is highly
recommended.
This Anti-Tip Kit (H-4) is only a precaution. It is not a substitute for proper adult supervision. Manufacturer
or retailer assumes no liability for improper installation or excess loads placed on screws, brackets, or
straps.
When properly installed, this restraint provides protection against unexpected tipping of furniture.
This Anti-Tip Kit MUST be installed into a wall stud using the proper mounting hardware. (Position of
Anti-tip Kit on product depends on wall stud locations).
H-4
Attach to the top back with screws
(included in the Anti-Tip Kit)
Connect with
plastic straps.
Attach to the wall stud
with screws
(included in the
Anti-Tip Kit)
2x
Children have died from
furniture tipover. To reduce the
risk of furniture tipover:
·ALWAYS install tipover restraint
provided.
·NEVER put a TV on this product.
·NEVER allow children to stand,
climb or hang on drawers, doors,
or shelves.
·NEVER open more than one
drawer at a time.
·Place heaviest items in the
lowest drawers.
This is a permanent label.
Do not remove!
WARNING