WowWee RobotZombie User manual

6+
USER MANUAL
ITEM NO.: 0920

02
RobotZombie™ Apocolypse!
Contents
X1 RobotZombie™
X1 Zombie Blaster X3 Foam Darts X1 Instruction Manual
RobotZombie™
Zombie Blaster
3 Foam Darts
Congratulations on your purchase of RobotZombie™!
At one time just a working robot, RobotZombie™ was infected with a mysterious Zombie virus,
and is now on the prowl to spread the infection.
Inside you will nd instructions on how to not only battle this mechanical menace in Zombie
Infection mode, but also how to take direct control and access his movements and functions!

1.5V “AAA” LR03 /UM4 1.5V “AAA” LR03 /UM4 1.5V “AAA” LR03 /UM4
1.5V“AA” LR6 / UM3 1.5V“AA” LR6 / UM3 1.5V“AA” LR6 / UM3 1.5V“AA” LR6 / UM3
03
Battery Detail
BATTERY REQUIREMENTS:
Your robot is powered by 4 x“AA”size Alkaline batteries
(2 batteries in each foot - not included).
Your zombie blasteris powered by 3 x “AAA”batteries (not included).
RobotZombie™ : Base of Feet Zombie Blaster: Side View
IMPORTANT BATTERY INFORMATION:
•Use only fresh batteries of the requiredsize and recommended type
•Do not mix old and new batteries, dierent types of batteries [standard
(Carbon-Zinc), Alkaline or rechargeable] or rechargeable batteries of dierent capacities
•Remove rechargeable batteries from the toy before recharging them
•Rechargeable batteries are only to be charged under adult supervision
•Please respect the correct polarity, (+) and (-)
•Do not try torecharge non-rechargeable batteries
re
•Replace all batteries ofthe same type/brand at the same time
•The supply terminals are not tobe short-circuited
•Remove exhaustedbatteries from the toy
•Batteries shouldbe replacedby adults
•Remove batteries if the toy is not goingto be played with for some time
•Robot will just stop when battery power gets VERY low. Power o and replace all batteries.
• Some lighting or sunlight can interfere with infra-red signals.
NOTE
LOW BATTERY INDICATORS:
When RobotZombie™ ’s batteries grow weak, your RobotZombie™ will move and walk very slowly
When this occurs, power robot OFF and replace all batteries.
When the Zombie Blaster’s batteries grow weak, RobotZombie™ will no longer respond to the
commands. Whenthis occurs, replace all batteries
BATTERY INSTALLATION:
• Be sure the robot powerbutton is in the OFFposition before installing or
changing batteries.
• Remove the battery covers with a Phillips/crosshead screwdriver as shown
(not included).
•Install recommended batteries as shown, making surebattery polarity iscorrect
(batteries not included).
• Replace battery doors and carefully tighten all screws.

04
RobotZombie™ Overview
Light Up
LED Eyes
Left
Chestplate
Right
Chestplate
Infra-Red
Receiver
Exploding
Arms
Front View
Exploding
Arms
Cranium
Plate

05
Speaker
Infra-Red
Receiver
ON/OFF
Switch
Removable
Arms
Back View
Removable
Arms
Cranium
Plate
Cranium
Plate

06
Zombie Blaster Overview
Forward
Back
Turn Right
Boost
SFX2
Command
RobotZombie™ to
shufe around!
Turn Left
Basic Controls
Note: Swivel the barrel to load the
next foam dart to the chamber.
Zombie Blaster - Side View
TOP View
• Do NOT store Zombie Blaster cocked and ready to re.
• Be sure to upload darts before storing away.
NOTE
CAUTION:
Do NOT aim at eyes or face.
TO AVOID INJURY:
Use only darts designed for this
product. Do not modify darts or
Zombie Blaster.
Discover hidden sounds by trying
different button sequences and
combinations!
SFX1
Command RobotZombie™
to burp, laugh maniacally,
or groan!
Hold for extended effect!
Barrel
Compression
Handle
Infra-Red
Transmitter
Trigger

07
Assembly Instructions
Click in arms
Tilt head forward Close Cranium Plates
1. Load Foam Darts, pull back compression handle
Blast off arms by hitting
the chestplates!
Hit him in the forehead to blast
open the cranium plates!
2. Press the trigger to fire 2
2
1 1

08
Advanced controls
Boost // /+
Boost RobotZombie™’s power core, increasing his speed!
Supercharge
Supercharge RobotZombie™’s memory circuits,
causing him to activate sounds and memories from
his past!
lurch
RobotZombie™ will suddenly lurch forward,
deecting incoming re!
+
+
Infection mode
Allow the Zombie virus to take over,
activating RobotZombie™’s Infection mode!
Hold down button for...?
• Standby Mode: After 3 minutes of inactivity, RobotZombie™’s
lights will shut down and he will enter Standby Mode. To exit
Standby Mode, press any button on the Zombie Blaster.
• Power Down Mode: After 5 minutes of inactivity,
RobotZombie™ will power down. To exit Power Down Mode,
activate the chestplate or cranium cover, or switch the power
OFF then ON again.
NOTE

09
To play Zombie Infection, rst make sure that RobotZombie™ is fully assembled.
Then, press quickly on the Zombie Blaster. RobotZombie™ will growl and his
eyes will start to blink as he moves around, searching for
uninfected machinery and humans.
To defeat him in time, you must blast off both his arms by hitting the two chest
plates rst, then hit him in the head to blast open his head plate before your time
runs out.
If you win, RobotZombie™ will be deactivated. If your time runs out before
deactivating him, you become RobotZombie™’s latest victim. Whether you win or
lose, you can still reassemble RobotZombie™ and take direct control or play Zombie
Infection again!
Zombie Infection Gameplay

010
CONTACT INFORMATION
To learn more about RobotZombie™ andrelated products, go to www.wowwee.com
Register your product at www.wowwee.com/register
If you have any questions that are not answered inthis user manual, refer towww.wowwee.com/support
This symbol is only valid in the European Union. If youwishtodiscardthis product, please contact your local authorities or dealer and ask for the
correct method of disposal.
The equipment that you have purchased has required the extraction and use ofnatural resources for its manufacturing. It may
contain substances that are hazardous to health andthe environment. In order to prevent the release of these substances into
the environment and toreduce the pressure on natural resources, we encourage youto use appropriate return systems. These
systems will ensure that most of the materials in your equipment are properly reused or recycled at the end ofits operational life.
The crossed-bin symbol invites to use these systems. For further information on collection, reuse and recycling systems, please
contact your regional waste management administration.