WRC F-One '017 User manual

INTRODUCTION
SAFETY PRECAUTIONS
Instruction Manual MUST be read and fully understood before to start building and operating
functions.
Always keep Instruction Manual in safety place, ready to be consulted for any reference you need.
Use only original WRC spare parts.
GENERAL INFORMATION
Assemble the kit only away from the reach of children.
Follow the building and operating instructions using the utmost care.
Don't put any part of your body inside rotating and moving elements as this may cause damage or
serious injury.
Check and clean the model before putting it away.
Don't use your model car in public places or in roads and areas where it could generate conflict with
person or vehicular traffic.
The model car is controlled by radio: you MUST put great care to avoid loss of radio control always
keeping a safety margin all around your model in order to prevent any collision.
Operating frequency: check and be sure it is clear and not shared with anybody at same time; it could
cause loss of control of the RC model.
Always turn on your transmitter before you turn on the receiver in the car and always turn off the
receiver before you turn off your transmitter.
Keep the wheels of the model off the ground when checking the operation of the radio equipment.
Disconnect the battery pack before storing your model.
WARRANTY
WRC guarantees this model kit to be free from defects in both material and workmanship within 30
days of purchase.
The total monetary value under warranty will in no case exceed the cost of the original kit
purchased.
This warranty doesn't cover any compnents damaged by use or modification or as result of wear.
Part or parts missing from this kit must be reported within 30 days of purchase.
No part or parts will be sent under warranty without proof of purchase.
If you find a defective or missing part, contact the local distributor.
Customer service and support will be provided through local hobby store.
No warranties are expressed or implied that cover damage caused by what is considered normal
use or cover or imply how long any model cars' components or electric components will last before
requiring replacement.
Due to the high performance level of this model car you will need to periodically maintain and
replace consumable components; any and all warranty coverage will not cover replacement of any
part or component damaged by neglect, abuse or improper or unreasonable use.
This includes but is not limited to damage from crashing, excessive moistur, improper use or no
maintenance or user modifications which compromise the integrity of components.
Warranty will not cover compnents that are considered consumable on RC model car.
WRC doesn't pay nor refund on any component sent from WRC or its distributor for warranty.
WRC reserves the right to make final determination of the warranty status of any component or part
Use only original WRC spare part:
CUSTOMER SUPPORT
Please don't hesitate to contact WRC support at [email protected] for any problem or question.
Also kindly visit our website www.wrc-racing.com to find last updates, set-up information, option
parts and other information.
W.R.C. world racing car s.r.l.
Via Meucci, 23/B
36040 Brendola (VI)
ITALY
Phone: [phone]
fax: [phone]
E-mail: [email protected]
Website: www.wrc-racing.com
F-ONE is a new generation high quality 1/10 scale touring car.
F-ONE is supplied in a box equipped with Instruction Manual.
Its use is intended for more than 16 years old persons with experience on rc model car field.
Children and all the persons without this requirement MUST have direct supervision of a
knowledgeable adult responsible.

TECHNICAL INFORMATION
- TRANSMISSION: 2 DRIVE WHEELS
- BODY: LEXAN FORMULA MODEL (NOT INCLUDED)
- ADJUSTABLE FRONT TOE, CAMBER AND CASTER
- ADJUSTABLE REAR HEIGHT
- BUMPER /FRONT BACKSTOP
- CARBON CHASSIS 2mm
- FULL BALL BEARING
- ADJUSTABLE DIFFERENTIAL
TECHNICAL DATA
- LENGHT .............................................418 MM.
- WIDTH .............................................190 MM.
- ADJUSTABLE WHEEL BASE ............269-265MM.
- WEIGHT CHASSIS..............................1080 GR.
REQUIRED BUT NOT INCLUDED IN THE KIT
ADDITIONAL ITEMS NEEDED FOR COMPLETION
LIPO BATTERY 7.4 V. ELECTRIC MOTOR
PINION GEAR
TOOLS REQUIRED
THESE TOOLS ARE NOT INCLUDED IN THE KIT BUT ARE REQUIRED FOR PROPER ASSEMBLY
SPEED CONTROLLER LOW PROFILE STEERING SERVO
TRANSMITTER
THE FOLOWING ITEMS ARE NEEDED FOR COMPLETION PF THE STX; THEY ARE NOT INCLUDED IN THIS KIT (UNLESS NOTED)
AND SHOULD BE OBTEINED FROM YOUR LOCAL HOBBY SHOP.
BE SURE TO READ THE INSTRUCTION COMPLETELY PRIOR TO ASSEMBLY
NOTICE:
RECEIVER
AA ALKALINE BATTERIES
FOR TRANSMITTER
WHEEL - TYRES - INSERTS
INCLUDED
LEXAN BODY+DECALS
INCLUDED
LIPO BATTERY TAPE
SOCKET:
5.5 MM
7.0 MM
ALLEN :
1.5 MM
2.0 MM
3.0 MM
RING PLIERS SIDE CUTTER
SCISSORS

02007-2
02035
02008-1
02028
02003-2
02035
03138 (GOLD)
02022-1
95007
Ø 7x1.5
92012
M3 x25
92005
M3 x14
94001
M 3x4
02036
92001
M3 x6
93002
M3 x8
02008-4
03044
03276
3x7x2
02006-2
02027
02041(TUNGSTEN CARBIDE) OPTIONAL
02041-1 (CERAMIC)IN KIT
02018
90004
8_12_3.5
02019-1
90018
5_10_4
94005-1
M 4x5
(ALUMINUM)
02023-1
Ø 4 IN KIT
RC0015 GREASE
03273
A
A
10
5,2
5
9,8
B
B
SCALA 1 : 1.5
3,3
ADJUST UNIBALL POSITION
TO OBTAIN "ZERO PLAY"
PLEASE SEE ATTENTION
3
BAG 1
PLAY ADJUST

02046
02029-2
93001
M3X6
02012-3
90001
6_10_3
02015
02029-1
CASTER
92001
M3 x6
02038
03069
93001
M3 x6
02009-5
92001
M3 x6
02003
02022-1
02033-3
95007
Ø7x1.5
02014
03044
03035-4
03044
02042-4
3mm
02053-1
90008
6_10_3
92002
M3 x8
02010-4
03262
03035-4
93002
M3 x8
92007
M3 x18
92001
M3 x6
92005
M3 x14
02050
02014
03276
3_7_2
93005
M3 x14
92001
M3 x6
92001
M3 x6
94009
02020-3
98010
M3x25
02020-2
03270
OFFSET
-3 MM. -2 MM. -1 MM.
0 MM. +1 MM. +2 MM. +3 MM.
CC
1
Threadlocker
BAG 2
4
3°

03170-7
03170-2
02043-4
95000
02043
02043-8
95001
12x1,6
03170-1
03170-3
03086
03170-11
99003
02043-4
3 HOLES
03170-4
03086
03086
13
CODE CST
RC0028 200
RC0028-1 300
RC0029 400 (IN KIT)
RC0062 500
RC0030 600
RC0063 700
RC0031 800
WRC SHOCKS OIL
6
5
43
2
1
SHOCK FILLING
Fully extend the piston rod so the piston is at the bottom of the shock body.
Hold the shock upright and fill the shock body with shock oil as in the picture.
Let the oil settle and allow air bubbles to rise to the top.
Slowly move the piston up and down until no more air bubbles appear.
Add shock oil as necessary.
Pull the piston rod most of the way out of the shock bod.
Let the shock rest for 5 minutes to allow the air bubbles to scape.
03170-8
2.6
COLOUR
Force (lb)
2.2
03170-6
2.1
03170-5
SPRINGS
COD
03170-7 2.3
03170-9
BLACK
YELLOW
BLUE
RED IN KIT
FUCHSIA
GREEN
1.4-3.5
1.3-2.9
PROGRESSIVE SPRINGS
03170-10
BAG 3
5

93001
M3 x6
02030-2
03069-2
03044
03035-6
03035-10
02081
93002
M3 x8
02017
02057
02003
02003
03139
02002
03136
03003-1
98006
M3 x16
02016-180
03035-4
FRICTION
HIGH
LOW
MEDIUM
92003
M3 x10
02003
3x5x2
98000
M3x3
03139-6
03276
3_7_2
(STANDARD)
02068
03003-2
92001
M3 x6
02068
95000
Lubricate
03035-6
03061-30
OPTIONAL 03061-30AL (ALUMINUM)
03035-4
18,5
RIGHT - LEFT
OPTIONAL
03061-30AL
(ALUMINUM)
03003-1 03003-1
03061-30
BAG 4
6

92009
02047
94001
02038
02053-2
93003
M3 x10
93003
M3 x10
02052-1
92001
M3 x6
92001
M3 x6
97005
98000
M3x3
02019-3
93003
02047
02045
94004
90000
5_10_4
DOUBLE SIDE TAPE
RECEIVER
NOT INCLUDED
TRASMITTER
NOT INCLUDED
RC 6032
93102
92001
M3 x6
02081-1
03085
BAG 5
7

93001
M3 x6
02039
02039
93001
M3 x6
95000
OR 101
02024-4
02040
8

- +
- +
1
2
1 2
ABSORBER
3
O-RING
R
G
GLD
1
2
FRONT
HEIGHT ADJUSTMENT
-3 MM. -2 MM. -1 MM.
0 MM. +1 MM. +2 MM. +3 MM.
MODE
NAME
CARPET
HIGH
LOW
REAR WING
VISCOSITY
DAMPER
OIL
DAMPER
REAR
FRONT
SPRINGS
REAR
FRONT
TYPE TYRES
SPUR PINION
DRIVE RATIO
MEDIUM
ASPHALT
LOW
TRACTION
SURFACE
TRACK CONDITION
TRACK
DATE
3°
6°
9°
12°
CASTER
BATTERY
POSITION
TOE
FRONT CAMBER
OUT IN
0UT IN
HIGH
GREY
GOLD
RED
G
GLD
R
PISTON HOLES
1
2
REAR HEIGHT
1
2
VIEW FROM TOP
9
ACKERMANN
2 mm 3 mm 4 mm
FRONT HEIGHT ADJUSTMENT
1° 1°
1.5 1.5
98
P-ONE
P-ONE
P01
P01
3 HOLES 400

- +
- +
1
2
1 2
ABSORBER
3
O-RING
1
2
FRONT
HEIGHT ADJUSTMENT
-3 MM. -2 MM. -1 MM.
0 MM. +1 MM. +2 MM. +3 MM.
MODE
NAME
CARPET
HIGH
LOW
REAR WING
VISCOSITY
DAMPER
OIL
DAMPER
REAR
FRONT
SPRINGS
REAR
FRONT
TYPE TYRES
SPUR PINION
DRIVE RATIO
MEDIUM
ASPHALT
LOW
TRACTION
SURFACE
TRACK CONDITION
TRACK
DATE
3°
6°
9°
12°
CASTER
BATTERY
POSITION
TOE
FRONT CAMBER
OUT IN
0UT IN
HIGH
PISTON HOLES
1
2
REAR HEIGHT
1
2
VIEW FROM TOP
10
ACKERMANN
2 mm 3 mm 4 mm
FRONT HEIGHT ADJUSTMENT

W.R.C. world racing car s.r.l. Via Meucci, 23/B 36040 Brendola (VI) ITALY
Phone: [phone] fax: [phone] [email protected]
wrc-racing.com