Step 3. Connect the motor and the ESC
Connect the corresponding color RED,YELLOW,BULE of the motor output line with the ESC line,if you
find the car is backward,please exchange the RED and BLUE line of the motor.
Step 4. Install the motorcycle battery and connect the battery with the ESC
1)Put the battery in the battery frame.
2)Use the rubber band to fix the battery.
3)Connect the battery with the ESC.
Caustion: When connect the battery with the ESC,please keep
the ESC in off state.Do not reverse the positive and
negative charges.
Step 5. Install the remote control battery and check the remote
control is working properly or not.
Note:The first use the ESC or New use of the remote control must re-calibrate the ESC.Please refer to the manual of the ESC.)
Step 6. Install the anti tilt rod roller group,toy and shell.
In order to avoid the damage in the transportation process, we pack the anti tilt rod roller group,toy
and shell separately. When open the package,find the parts,install and fix well.
1)Install the side slider set ,and then put the side slider set into the side slider arm post lock each of the grains
2)Install the rider handle, and then mount the rider in the body upper shell, fix the tail of the body upper shell with R-clip.
3)Install the body lower shell on the main frame,fix the body shell post with the R-clip.
