Xenios The Nano Timer User manual

Thanks for choosing our products!
Follow us on:
User Manual

Product Details:
• Item: 6-digit 1-inch Xenios USA® Nano Timer
• Dimension: 155mm X 47 mm X 22 mm
• 1-inch-tall crystal clear bright led display for maximum visibility.
• Material: silicon case with acrylic lens, easy-to set integrated buttons on the top.
• The Nano Timer is supplied by an internal Lithium Battery 800mAH - 3.7V
• Power adapter charger specs: AC 110V-240V – Output DC 5V 1A with Type C
USB cable. Power adapter is not supplied with the Xenios USA® Nano
Timer.
• Warning: to recharge the Nano Timer battery with a wrong voltage may result into
product damages that will not be covered by the product warranty.
• Internal battery capacity: full charged in 3 hours, lasts 10 hours.
• Special Features: built-in powerful magnet on the timer back side to let the Timer
be mounted on metal surfaces.
General Settings:
There are 7 modes on the software of the Xenios USA®Nano Timer.
1. Clock: 12-hour/24-hour HH:MM time display.
2. Countdown timer: programmable, max countdown from 99:59. Format: dn MM:SS.
3. Count-up timer: programmable, max count up to 99:59. Format: UP - MM:SS
4. Workout Interval timer (3x): programmable workout time, rest time and rounds,
up to 99 rounds. On the memory of the timer can be saved up to 3 different Interval
Training modes (under the same program mode called 01).
5. TABATA timer: pre-programmed interval timer, 8 rounds of 20 seconds workout and
10 seconds rest.
6. FIGHT GONE BAD timer: pre-programmed interval timer, 3 rounds of 5X1 minute
workout and then 1 minute rest.
7. Stopwatch: count up from zero up to 99 minutes 59 seconds and 99 hundredths of
a second. Format: MM: SS: MS.
At First
• Press the FUNCTION button to select the desired above listed mode.
To start theMost Recently Used Workout Program:
• Press the START button to start, just after having pressed the FUNCTION button
to select the Interval Timer mode.
To Set aNew Workout Program:
• Hold the SET button for 3 seconds to enter the setting mode. The first digit starts
blinking.
• Set the target time by pressingthe +/- button andthen store it by pressing again
the SET button.
• Each next pressing ofthe SET button will move on to the next digit setting. Press and
hold +/- button to quickly change the value of the digit.
• Press and holdthe SET button for 3 seconds to exit and save the whole settings.
Timer stops blinking.
• Pressthe START button to begin or stop the just set Workout Program.
• To reset a timer: pause the timer and then double fast tap START button
Clock:
• Press the FUNCTION button to select the clock function. Or hold START button
for 3 seconds to turn on the display. Timer displays the clock function every time it is
powered on.
• To change the time, hold the SET button for 3 seconds to enter the setting mode,
the first digit starts blinking.
• POWER button: press and hold POWER button for 3 seconds to turn on/
off the timer.
• +/- button: press to increase/decrease the value. Hold the number button for
fast increase or decrease.
• +/- button: press to adjust brightness across 4 levels.
• FUNCTION button: select between 7 functions mode.
• SET button: press and hold for 3 seconds into setting mode.
• START button: press to start/stop the timer.
• Reset: stop the timer before resetting it. Double fast tap the START button
to reset.
• Battery status: small red light on the top. Led light turns on when timer is being
charging, and turns off when full charged. Timer displays “Lo” when battery is low.
• Press and hold FUNCTION to activate/deactivate the Nano Timer sound.
Standard time (12-hour) Military time (24-hour)
Button Layout:

• Set the target time by pressingthe +/- button andthen store it by
pressing again the SET button.
• Each next pressing ofthe SET button will move on to the next digit setting.
Press and hold the +/- button to quickly change the value of the digit.
• Press and hold the SET button for 3 seconds to exit and save the whole
settings. Timer displays time normally.
• Double fast tap the SET button to shift between 12-hour and 24-hour
display format.
• Pressthe +/- button to adjust the brightness across 4 levels.
Countdown Timer dn:
• Press the FUNCTION button to select the countdown timer function.
• To set a new countdown timer, hold the SET button for 3 seconds to
enter the setting mode, the first digit starts blinking.
• Set the target countdown time by pressing +/- button and then store it by
pressing again the SET button.
• Each next pressing of the SET button will move on to the next digit setting.
• Press and holdthe SET button for 3 seconds again to exit and save the
settings.
• Pressthe START button to begin the just set countdown timer.
Count up Timer UP:
• Press the FUNCTION button to select the count-up timer function.
• To set a new count-up timer, hold theSET button for 3 seconds to enter
the setting mode, the first digit starts blinking.
• Set the target time by pressing the+/- button andthen store it by
pressing again the SET button. Each next pressing ofthe SET button
will move on to the next digit setting.
• Press and holdthe SET for 3 seconds again to exit and save the whole
settings.
• Pressthe START button to begin the just set count-up timer.
Workout Interval timer 01 (3x):
Interval timer function allows you to set any interval time workout programs
made of workout time and rest time segments. Timer beeps once when
workout time ends and beep twice when rest time ends.
• Two green digits display the round number, another 4 digits display MM:SS
format time.
Set workout time Set rest time
• Press FUNCTION button to select the interval timer function.
• Press and hold the SET button for 3 seconds to enter the setting mode,
the first green digit starts blinking.
• Set the number of rounds by pressing the +/- button.
• Press the SET button for 3 seconds to set H1 workout time
• Set the workout time by pressing the +/- button and then store it by
pressing again the SET button. Each following SET button press will
move on to the next digit setting.
• Press the SET button for 3 seconds to set H2 rest time.
• Set the rest time by pressing the +/- button and then store it by pressing
again the SET button. Each following SET button press will move on to
the next digit setting.
• Now you can set the Beep Pacer. The timer will show this display:
Here can be set how often you want to hear the beep during training. Enter
the value by pressing +/- , press the SET button to move between
the values to be set. Press and hold SET for 3 seconds to save the Beep
Pacer.
• Once all settings are completed, press and holdthe SET button for 3
seconds to save all and exit the settings. Timer stops blinking.
• Before pressing START , you can choose whether to send the work and
recovery time UP or DOWN. Quickly double tap the SET button to switch
between up and down.
• Pressthe START button to start the just set workout interval timer
program.
• Three different Interval Timers can be saved, following the same procedure
described above also for the next screens of program 01, which are 3 in
total. Once set, they will remain saved in the memory of your Nano Timer.
TABATA timer F1:
Pre-set TABATA timer workout mode consists of 8 rounds of 20-second
workout time and 10-second rest time. The timer beeps once when workout
time ends and beeps twice when rest time ends.
• Press the FUNCTION button to select the TABATA timer function.
• Pressthe START button to Start/stop the workout timer.
• Double fast tapthe START button to reset the timer.
FIGHT GONE BAD timer F2:
Pre-set FIGHT GONE BAD timer workout mode consists of three 5-minute
rounds and 1 minute rest time between each round. The timer beeps once
for each 1-minute workout time start and beeps twice for each 1-minute rest
time start.

• Press theFUNCTION button to select the FIGHT GONE BAD timer function.
• Pressthe START button to start/stop the workout timer.
• Double fast tapthe START button to reset the timer.
Stopwatch F3:
Timer will count up from zero (minutes, seconds and hundredths of a second format).
• Press the FUNCTION button to select the stopwatch function.
• Pressthe START button to start/stop the timer.
• Double fast tapthe START button to go back to zero.
Sku: XSXFITTM04 Release Date: 2021-06-28
Xenios USA®always recommends to carefully read all Warranty rules, Care and Maintenance instructions and Safety &
Usage guidelines, before to use a Xenios USA®product. Above charts are all available at
www.xeniosusa.com Xenios USA®reserves the right to change product design, construction materials and specifications
at any time without notice. While every effort has been made to ensure that all graphic representations and descriptions
of goods available from Xenios USA®correspond to the actual goods, Xenios USA®and/or its International Licensee are
not responsible for any variations from these descriptions. Error & omissions excepted. Some of the products could not
be available within all countries.
The Xenios USA®registered trademark is owned, by and used under license from Xenios LLC – NY (USA)
After Sales Service:
DUKE Spa Strada Acquasalata, 4 - 47899 Serravalle San Marino
[email protected] - Fax: [phone]
International Licensee
Imported by:
DUKE Spa Strada Acquasalata, 4 - 47899 Serravalle San Marino
[email protected]
International Licensee
© XENIOS USA LLC – NY (USA) all rights reserved. The use and the copy of all the contents are not allowed, without the
authorization of XENIOS USA LLC. Xenios USA®trademark and all the Registered Design Patents are owned by and used
under the license from XENIOS USA LLC – NY (USA)
Warning
• Do not try to supply the device by using a wrong output voltage AC adaptor. Warranty will void.
• Do not use the Nano Timer in a damp environment and do not drop water on it and warranty will
void.
• Operative Temp: from -10 C° up to +40 C°. The use of the Timer out of such temp range, will
result in to a warranty void.
• Do not try to open or repair the Nano Timer by yourselves. Warranty will void.
• The Xenios USA Nano Timer is an electronic item, thus it must be wasted according to the current
laws about such items’ category wasting. Contact your Xenios USA distributor in order to be
informed about the proper way to waste the item without being charged of any fee.