Xerox Phaser 480X User manual

Repacking your printer
1. Turn off the printer; remove all cords and cables.
2. Slide the cover release to open the top cover.
Caution To keep your warranty valid, you must ship the printer in its
Tektronix shipping box, taking reasonable care to repack it
properly. Failure to do so will result in damage to the printer.
Call Tektronix if you need a replacement box. Also, if you are
returning the printer for service, call Tektronix for a return
authorization number.
3. Remove the paper tray and repack it for shipping:
a. Insert the two small foam shipping blocks into the paper tray
on either side of the metal plate.
b. Secure the cover to the paper tray. Use masking tape.
Note If you are shipping the printer for service, you do not need to
return the paper tray.
8849-03a

4. Remove the transfer roll tray; remove the transfer roll from the
tray and wrap the tray in packing material.
5. Insert the medium-sized foam shipping block inside the printer
behind the paper guide.
6. Attach the long foam shipping block to the paper clamp bar:
a. Use the black rubber belt to move the paper clamp bar so that
it is positioned directly over the label
Position paper clamp bar
HERE to clear a paper jam
.
b. Insert the shipping block under the paper clamp bar.
c. Use the two tie-wraps to secure the block to the paper clamp
bar. Attach them on the righthand side where there is open
space beneath the paper clamp bar. Make sure that they are
tightly secured.
5
8849-71

6a
6b
6c

7. Place the two rubber cushions, marked L (left) and R (right), onto
the metal bar on either side of the platen. Make sure that the
rubber cushions are positioned with the posts
upright (or leaning
slightly forward)
and facing outward as shown.
Caution The rubber cushions protect the thermal head. If they are
positioned incorrectly, the thermal head will be damaged
in shipping.
8. Replace the transfer roll tray inside the printer.
9. Close the top cover; the thermal head must be resting on the
rubber cushions.
10. Secure the top cover closed. Use masking tape.
L
8849-73A
L
7


11. Repack the printer in the Tektronix shipping box. Keep the
printer level when moving.
Source: 070-9237-00 AC
8849-50
Phaser
480
ERROR JAM MEDIA TRANSFER
ROLL COVER READY POWER