Yakima LoadWarrior User manual

(1x)
(2x)
(3x) (3x) (3x) (11x)
(4x) (4x)
(4x)
(4x)
(4x)
(4x)
LoadWarrior
RECOMMENDED TOOLS:
Phillips screwdriver
Tapemeasure or ruler
With a crossbar spread of 24–29” (61cm-
74cm), you may carry bikes, skis, or kayaks,
provided you do not exceed the recommended
weight limit for your vehicle.
 

 

Carry gear in the basket, and attach
accessories directly to the LoadWarrior
(using accessory instructions).

IF YOU HAVE BARS THAT CAN BE MOVED…



DO NOT ATTACH BRACKETS


•IfyouhavefIxedbars: •IfyourbarsMove:
(SIDE VIEW)
A friend
would make
this easier .
QTowerowners:
neverreposITIonTheQTowers! TIghTenyourcrossbars IfyouloosenedTheM.

OR BARS THAT CANNOT MOVE…
Continue to STEP 

Pry open the
SnapArounds,
attach them
to the LOWER
FRONT BAR.
 
washers, fairing

 
NOTE: The fairing can fold down when
carrying long slender loads.
Remove the machine screws from

NOTE
machine screws
with washers (from
LoadWarrior) into same

You may find tapered
screws with your
Extension.
MACHINE
SCREWS
TAPERED
SCREWS
DO NOT insert the tapered


EXTENSION
USERS:
Insert screws with
washers into each
of the joints and

ASSEMBLE


ATTACH THE KNOBS:
Engage the threads of
the bolts.
CHECK INSTALLATION:
Make sure installation is secure
by tugging at basket.
On some
vehicles, hatch
interference is
unavoidable.
TO REMOVE THE BASKET, DO NOT
DISASSEMBLE THE HARDWARE.
 

 

 
USE CAUTION WHEN

T-BOLT IS LOCKED

bolt is turned inside
the hole:
TIghTen
TheKnobs.
SECURE THE
BASKET TO


POSITION THE SUPPORT BRACKETS
ABOVE 
 
OUTSIDE of the basket

 
face 
It may be necessary to
move the bracket to a new
position, or to adjust the
basket position.
Keepbar
belowTab!

Position cover bracket onto installed

Hooked tab should cover the larger
support bar.
Arrow points inboard
to center of vehicle.

Insert bolt into round hole,
and T-bolt into slotted hole.
The basket should NOT
SLIDE on the bars.
Tighten knobs if
necessary.
•conTInueTo bacKpageforIMporTanTloadlIMITaTIons...