Yakima LOCKN'LOAD Instruction sheet

09-13-593-Rev2 1/4
• Please read instructions carefully before installation.
• Check the contents of kit. Contact your YAKIMA dealer if any parts appear missing or damaged.
• Clean your platform prior to fitting the LOCKN’LOAD Gas Bottle Restraint kit.
• Place these instructions in the vehicle’s glove box after installation is complete.
FIRST TIME INSTALLATION
KIT CONTENTS
ITEM COMPONENT QTY
1. Gas Bottle Restraint Strap x1
2. Ratchet Strap x1
3. M10 Eye Bolt x2
4. M10 Washer x2
5. M10 T-Nut x2
6. Baseplate x1
7. Protective Tape x3
®
PLATFORM SOLD SEPARATELY
PLATFORM GAS BOTTLE RESTRAINT KIT
1
3
2
4
5
LOCKN’LOAD
TM
6
7

09-13-593-Rev2 2/4
INSTALLATION
LOOSELY ASSEMBLE COMPONENTS ONTO BASE PLATE
Loosely assemble the Eye Bolts, Washers and T-Nuts to the Baseplate ensuring the T-Nuts are
placed under the plate. Ensure there is enough slack between the T-Nuts and the Baseplate
to allow the T-Nut to slide under and along the slat channels of the platform.
1
POSITION BASEPLATE
Determine where on the platform you wish
to install the gas bottle holder.
Place Baseplate onto platform and
manoeuvre Baseplate until left-most T-Nut
drops into closest slat channel cutout.
Slide the Baseplate along the slat channel
until the other T-Nut can be inserted in the
slat above to the right. Position Baseplate
to desired position.
2
x2

09-13-593-Rev2 3/4
SECURE STRAPS
Place the Restraint Strap over
the top of the 4kg Gas Bottle
and attach the hooked end to
Eye Bolt.
Feed the unhooked end of the
Restraint Strap through the
Ratchet. Attach the Ratchet
Strap hook to the other Eye
Bolt.
Tighten Ratchet until gas
bottle is firmly secured.
5
SECURE EYE BOLTS
Tighten Eye Bolts.
A tool such as a screwdriver, placed
through the eye of the bolt, may be
used for leverage to tighten the Eye
Bolt firmly.
3
• If straps become contaminated with oil, fuel or acid remove with hot soapy water.
• If the ratchet mechanism becomes stiff in use, a small amount of lubrication applied to the moving parts will
ease operation.
• Ratcheting strap must not be used for lifting. Protect from abrasion and friction. Do not tie knots in the straps.
Do not use a damaged strap.
• 150kg lashing capacity on the polypropylene webbing.
MAINTENANCE AND SAFETY
x2
APPLY PROTECTIVE TAPE
Remove backing off
Protective Tape and apply
as required to the top
surface of the Baseplate
to prevent scratching.
4
x3

09-13-593-Rev2 4/4
www.yakima.com.au
YAKIMA PRODUCTS, INC.
4101 Kruse Way
Lake Oswego, OR
97035-2541
USA
888 925 4621
YAKIMA EUROPE
Archimedesbaan 25
3439 ME Nieuwegein
The Netherlands
[phone]
YAKIMA AUSTRALIA PTY. LTD
17 Hinkler Court
Brendale, QLD 4500
Australia
1800 143 548