PRESS If you see a screen saying that you are not successfully connected,
you may need to set up your instrument to connect to your
network. To do so, press [Setup], then [Network] from your remote
control.
CONFIRM
NETWORK
SETTINGS
Here you can update your DHCP, DNS, proxy, and manual IP
settings. In most cases you will not need to edit these settings.
Unless you are manually assigning DNS or IP locations for your
instrument, you can set DHCP to "On" and your network should
automatically configure the settings to connect successfully.
If you want to enter your DNS server addresses manually, you can
choose "DHCP and DNS".
If you also want to enter your IP address, subnet mask, and
gateway server information, select "Manual." Also, if you're using a
proxy server you will need to enter its name and port here in order
to connect.
Note: If you have any questions about the settings for your
network, please contact your internet service provider or refer to the
documentation for your router.
PRESS After entering and confirming your network settings, return to the
Internet Direct Connection home page by pressing "Internet" on
your remote.
Attention:
*Once connected to Internet Direct Connection, you'll be able to enjoy Yamaha's Piano Radio services. Don't have a
subscription? Get one now.
*If you have connected successfully and would like to view Radio Service for Piano playback instructions, visit Playback
Instructions.
6/4/2011
amaha: Connect to Radio Service For …
…yamaha.com/connect/wirelessType?t… 2/2
