1. In order to get a more efficient charging experience, please use the provided power
adapter.
2. Do not put metal debris or magnetic cards on the charging board to avoid abnormalities
or damage to the charger.
3. In order to get a more ecient charging experience, please do not charge too far away
from the charging iron.
4. If the receiving coil or the transmitting board is overheated and the charging stops (the
charging indicator light keeps ashing), please remove the charging product, wait for it to
cool down, and try charging again.
5. The indicator light keeps ashing, there are three possible situations:
• Indicate that the position is not properly placed, and re-place the charging object. After the
position is calibrated, until the indicator light is always on, the battery will be charged nor-
mally.
• To ensure a certain degree of safety, the product has an overheating alarm. After the mobile
phone or the charging object cools down, it will automatically eliminate the flicker and enter
the normal charging state.
• Put metal debris or magnetic card on the charging board, and remove the metal object or
magnetic card.
6. After the device is fully charged, the indicator light will flicker about 15 seconds apart. You
can check the charging device to confirm whether it is fully charged.
Notes for BHC76 (optional)
Safety Guide for BHC76 (optional)
1. Do not disassemble this product by yourself or throw it into re or water to avoid short
circuit leakage or damage to the product.
2. Please do not use this product in high temperature, humidity or corrosive environment, to
avoid damage to the circuit and lead to failure to charge or other failures.
3. Do not expose the product to corrosive liquids, otherwise it will cause serious damage.
4. Do not disassemble or modify this product for any reason to avoid secondary failure and
burnout.
5. Do not place the product below -10° C or above 60° C.
6. Do not knock, throw or vibrate this product strongly. Rough methods will damage the in-
ternal circuit board structure.
