YYZ Lighting LFW Series User manual

MOUNTING DISTANCE
IP67
WATER
PROOF
Mono
LINEAR FLEX WASHER - LFW SERIES
INSTALLATION MANUAL
Page 1 of 3
LFW Series
YYZ Lighting Inc., 1175 Squires Beach Rd, Unit 2, Pickering, ON L1W 3V3, Canada. www.yyzlighting.com
D
Mounting Distance
Beam Angle 30°
1400mm
1600mm
3000mm
3500mm
1200mm
1600mm
2800mm
3200mm
1450mm
2050mm
3050
3950
D
Mounting Distance
Beam Angle 45°
D
Mounting Distance
Beam Angle 60°
D
Mounting Distance
Beam Angle 20*45°
D=50mm
D=50mm
D=50mm
D=100mm
D=100mm
D=100mm
D=200mm
D=200mm
D=200mm
1500mm
2100mm
3100mm
4000mm
D=50mm D=100mm D=200mm D=300mm
D=300mm
D=300mm
D=300mm

INSTALLATION WITH ADHESIVE TAPE
INSTALLATION WITH STAINLESS STEEL MOUNTING CLIP
INSTALLATION WITH SILICONE MOUNTING CLIP
Page 2 of 3
LFW Series
YYZ Lighting Inc., 1175 Squires Beach Rd, Unit 2, Pickering, ON L1W 3V3, Canada. www.yyzlighting.com
LINEAR FLEX WASHER - LFW SERIES
INSTALLATION MANUAL
Take the product from the packaging box
and tear off the tape on the back.
Connect the product to the low-voltage driver
and energize it.
Install the product on where needed (ensure
the wall is smooth) and srick it firmly.
(refer to the installation diagram of mounting
distance for the specific glowing effect)
Take the stainless steel mounting clips and
screws from the packing box, and use a
screwdriver to install these clips where
needed.
Connect the product to the low-voltage driver
and energize it.
Take the light out of the box, then put the light
installation into the clips and secure it (refer to the
distance diagram for the specific glowing effect).
Place the light where needed( refer to the
installation distance diagram for the specific
glowing effect).
Connect the product to the low-voltage driver
and energize it.
Take the silicone mounting clips and
screws from the package box, and fix these
clips with a screwdriver.

INSTALLATION WITH ALUMINUM PROFILE
WIRING DIAGRAM
Page 3 of 3
LFW Series
YYZ Lighting Inc., 1175 Squires Beach Rd, Unit 2, Pickering, ON L1W 3V3, Canada. www.yyzlighting.com
LINEAR FLEX WASHER - LFW SERIES
INSTALLATION MANUAL
Take the light, aluminum profile and angle mounting
clips from the box, and fix the angle mounting
clips to the needed position with a scre w-
driver.
The specific glowing effect can be adjusted
according to the needs of the application. Aer
installation, connect the light to the
low-voltage driver and energize it.
Put the light into the aluminum profile, and
press the light down along the profile to
ensure the light is tightly stuck into it. Then
fasten the profile on the angle mounting clips
(according to the glowing angle requirements,
as the angle mounting clips can be adjusted).
POWER
SUPPLY
INPUT
AC