YYZ Lighting LFX Series User manual

products are delivered in appropriate packaging. Any handling instructions on the packaging must be observed. Products
transportation, storage or handling.
products contain precision electrical components and are not designed to withstand excessive
stresses from tension or compression.
LED products.
regulations or standards. (Improper installation can create an electrical hazard with risk of electric shock, fire or injury).
will not be held responsible for any consequences arising from improper product handling, storage or installation.
products must be installed as supplied. Disassembly, modification or attempted repair will invalidate warranty and may
create an electrical hazard.
The YYZ product warranty is available with this document or in the following website - www.yyzlighting.com
accessories, tools and fixings where specified.
Product specification and installation information is also available from the YYZ website www.yyzlighting.com
cable type and connection points along with positioning and rating of power supplies and any control gear. Refer to all product
cable length.
12V DC or 24V DC
specifications.
luminaires with careful use of a soft dry cloth.
example DO NOT USE
Sodium Carbonate.
cleaner or with cool, soft water diluted (5% or less) bleach (Sodium Hypochlorite) solution.
earthed. Avoid physical contact between adjacent LED products.
be kept clean and dry and free of paints and solvents.
connectors where they will not cast shadows.
over 250mm) or external impact during handling or installation.
INSTALLATION GUIDE
LFX Series
PRODUCT CARE AND HANDLING
SAFETY AND WARRANTY
PREPARATION
AFTER INSTALLATION
READ BEFORE INSTALLATION
LFX Series Page 1 of 3
YYZ Lighting Inc., 1175 Squires Beach Rd, Unit 2, Pickering, ON L1W 3V3, Canada. www.yyzlighting.com

INSTALLATION GUIDE
LFX Series
Handle strip carefully. Cut strip
on on dotted mark with sharp
scissors
Carefully solder with prepared
cables on the marked contacts.
Minimise contact with heat tip to
avoid heating the PCB
Check the Polarity and connect
with locally available connectors
Remove backing from adhesive
tape
Ensure Mounting surface is clean Press in Profile, dont press
direct pressure to LEDs
123
Drill for Screws to Fix clip with
suitable screw supplied ( min 5 to
6 clips per Mtr )
Place Strip in clip and fix
remaining screw.
check the connections
CONNECTING IP20 FLEX STRIP
MOUNTING - SELF ADHESIVE TO PROFILE
MOUNTING - CLIP MOUNTING
LFX - Series Page 2 of 3
YYZ Lighting Inc., 1175 Squires Beach Rd, Unit 2, Pickering, ON L1W 3V3, Canada. www.yyzlighting.com
123
123

undamaged and conductors free from dirt and corrosion.
electromagnetic interference.
before power is switched on. Take particular care not to confuse any control and power wiring. Do not remove any supplied product
cable labels.
not exceed the recommended load.
tapes and sealants, potting compounds and IP rated junction boxes as appropriate to the installation and operating environment.
24V DC
INSTALLATION GUIDE
LFX Series
LFX - Series Page 3 of 3
YYZ Lighting Inc., 1175 Squires Beach Rd, Unit 2, Pickering, ON L1W 3V3, Canada. www.yyzlighting.com
READ BEFORE INSTALLATION
WIRING SYSTEM DIAGRAM
SWITCH (ON/ OFF)
DIMMING WITH 0-10/ DALI / DMX