Zacuto Z-Finder Eyecup Instruction Manual

Installing your Z-Finder Eyecup
1Remove existing accessories 2Turn the red diopter clockwise
until it stops (should be raised all
the way up)
3Replace antifog and sunshield on
top of lens
4Take the new eyecup and secure the
lens cap to the base of the eyecup
as shown
5Line up lens ring with the groove inside the
lower lip of eyecup
6Apply pressure evenly around upper opening
of eyecup, then press firmly
7Place lens cap over lens and secure tightly

Installing your Z-Finder Eyecup
8
10 Lightly pinch tall end of eyecup and slide
boot on
11 Anchor one side of boot and slide over
eyecup to final position covering all of
the threads
Apply pressure with thumbs to hold lens
cap and eyecup firmly in place to avoid
smudging the antifog shield
9Flip Z-finder unit upside down to snap
lower lip of eyecup completely over
the lens ring
Precaution
!
For more information,
watch our tutorial video
at Zacuto.com
*
Fully assembled
See Precaution
!
See Precaution
!