Zico QUIC-RELEASE QR-FEH-1-S Parts list manual

ZICO®
3030PM25
QUIC-RELEASE®

 Rev. 11-29-21
  DESCRIPTION 
1 3030-300-105 RETAINER BRACKET 1
2 3030-300-101 BASE BRACKET 1
3 3030-300-107 BAND CLAMP 1
4
3030-300-111 LABEL, MODEL QR-FEH-1-A
1
3030-310-111 LABEL, MODEL QR-FEH-1-K
3030-315-111 LABEL, MODEL QR-FEH-1-B
3030-320-111 LABEL, MODEL QR-FEH-1-S
5 3030-300-113 BAND CLAMP CAP 1
6 3030-300-117 RETAINING PIN / LANYARD ASSY 1
7 3030-300-119 LABEL, RETAINING PIN 1
9 3030-300-121 FOAM PAD, 3-3/4" x 1-1/4" x 1/4" 1
10 3030-300-123 FOAM PAD, 2-1/2" x 1/1/4" x 1/4" 1
11 3030-300-125 LABEL, DO NOT ADJUST 1
MODEL DESCRIPTION


QR-FEH-1-A For use w/ Amerex B402 & B500 2.45
QR-FEH-1-B For use w/ Badger 5MB-6HB 2.45
QR-FEH-1-K For use w/ Kidde Pro Series 340 2.45
QR-FEH-1-S For use w/ Sentry AA05S-1 2.45

Attach Lanyard Assembly here.
Lanyard Assembly tab serves as at
washer.
Slide Retaining Pin through hole in Band
Clamp latch to secure.
Note that two fasteners sets must go through
the bottom holes of the Base Bracket and
that two fastener sets must go through the
shared holes of the Retainer Bracket and the
Base Bracket.
Mount at four points
with Grade 5, 1/4"
Type 4 hardware.
Page 2

Ziamatic Corp.
    
.

  
Page 3
WARNING: QM-FEH-1 is to be secured with a minimum of Grade 5, 1/4” Type 4 fasteners and washers. Failure
to do so may result in non-compliance with safety standards.
WARNING: Be careful not to kink the Band Clamp (3) during mounting procedures.
WARNING: Band Clamp is factory set. Do not adjust adjustment screw. It is permanently bonded with adhesive.

Mount horizontally or vertically at four points to any at surface using a minimum of Grade 5, 1/4” Type 4
fasteners and washers (see Page 2). Failure to meet these requirements may result in non-compliance with safety
standards.

1. To stow the extinguisher:
• Place the extinguisher against the Base Bracket (2), inside of the Band Clamp (3) and resting on the
footplate. The neck of the extinguisher should sit fully inside the Retainer Bracket (1).
• Hook together and fully close the Band Clamp latch. Slide the Retaining Pin (6) through the small hole in
the Band Clamp latch to secure. Failure to use the Retaining Pin may result in non-compliance with safety
standards.
2. To retrieve the extinguisher:
• Remove the Retaining Pin (6) and open the Band Clamp (3) latch.
• Pull extinguisher free from the Retainer Bracket (1).